Comparison Between Linear and Nonlinear Fracture Mechanics Analysis of Experimental Data for the Ductile Superalloy Haynes 230

Abstract

With increasing use of renewable energy sources, an industrial gas turbine is often a competitive solution to balance the power grid. However, life robustness approaches for gas turbine components operating under increasingly cyclic conditions are a challenging task. Ductile superalloys, as Haynes 230, are often used in stationary gas turbine hot parts such as combustors. The main load for such components is due to nonhomogeneous thermal expansion within or between parts. As the material is ductile, there is considerable redistribution of stresses and strains due to inelastic deformations during the crack initiation phase. Therefore, the subsequent crack growth occurs through a material with significant residual stresses and strains. In this work, fatigue crack propagation experiments, including the initiation phase, have been performed on a single edge notched specimen under strain controlled conditions. The test results are compared to fracture mechanics analyses using the linear خ”K and the nonlinear خ”J approaches, and an attempt to quantify the difference in terms of a life prediction is made. For the tested notched geometry, material, and strain ranges, the difference in the results using خ”Keff or خ”Jeff is larger than the scatter seen when fitting the model to the experimental data. The largest differences can be found for short crack lengths, when the cyclic plastic work is the largest. The خ”J approach clearly shows better agreement with the experimental results in this regime.