Search
Journal of Engineering for Gas Turbines and Power
EISSN: 1528-8919
ISSN: 0742-4795
Priority: 12
Publisher: American Society of Mechanical Engineers
Description: The Journal of Engineering for Gas Turbines and Power publishes archival-quality papers in the areas of gas and steam turbine technology, nuclear engineering, internal combustion engines, and fossil power generation. It covers a broad spectrum of pra More ...
CSV
RISCylinder-to-Cylinder Variations in a V6 Gasoline Direct Injection HCCI Engine
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Despite the fact that homogeneous charge compression ignition (HCCI) has been demonstrated as a combustion technology feasible for implementation with different fuels in various types of engines, ...
Experimental Study of Oxygen-Enriched Diesel Combustion Using Simulated Exhaust Gas Recirculation
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The techniques of design of experiments were applied to study the best operational conditions for oxygen-enriched combustion in a single-cylinder direct-injection diesel engine in order to reduce ...
Secondary Air System Component Modeling for Engine Performance Simulations
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper describes the modeling of typical secondary air system elements such as rotating orifices, seals, and flow passages with heat and work transfer from the surrounding surfaces. The ...
Analysis of NOx Formation in a Hydrogen-Fueled Gas Turbine Engine
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A commercially available natural gas fueled gas turbine engine was operated on hydrogen. Three sets of fuel injectors were developed to facilitate stable operation while generating differing ...
Mechanical Investigation of a Failed Lock-Pin
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents the outcomes of computational mechanics applied in the root-cause investigation on hot section failure of a 25 MW gas turbo generator in the domestic power plant after 2228 ...
Combustion Performance of Biodiesel and Diesel-Vegetable Oil Blends in a Simulated Gas Turbine Burner
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Recent increases in fuel costs, concerns for global warming, and limited supplies of fossil fuels have prompted wide spread research on renewable liquid biofuels produced domestically from ...
The Influence of Dump Gap on External Combustor Aerodynamics at High Fuel Injector Flow Rates
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The increasing demand to reduce fuel burn, hence CO2 emissions, from the gas turbine requires efficient diffusion to reduce the system pressure loss in the combustor. However, interactions between ...
Supplementary Backward Equations v(p,T) for the Critical and Supercritical Regions (Region 3) of the IAPWS Industrial Formulation 1997 for the Thermodynamic Properties of Water and Steam
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: When steam power cycles are modeled, thermodynamic properties as functions of pressure and temperature are required in the critical and supercritical regions (region 3 of IAPWS-IF97). With ...
Nonlinear Identification of Mechanical Parameters in a Squeeze Film Damper With Integral Mechanical Seal
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: End seals in squeeze film dampers (SFDs) aid to increase their damping capability while maintaining low lubricant flow rates and reducing the severity of air ingestion. This paper presents ...
Development of High-Temperature Transport Technologies for Liquid Cadmium in Pyrometallurgical Reprocessing
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Pyrometallurgical reprocessing is one of the most promising technologies for the advanced fuel cycle with favorable economic potential and intrinsic proliferation-resistance. The feasibility of ...