| description abstract | Liquid crystal displays (LCDs) are getting larger, and the homogeneity of an LCD panel is becoming very important for the quality of the display. Inhomogeneity in an LCD panel can be caused by inhomogeneity of its materials and the defective production process, warpage of the panel due to changes in the temperature and humidity, and so on. In this study, we developed a scheme of hygromechanical analysis to reduce the warpage of an LCD. First, we measured the diffusion coefficients and Henry's law coefficients of the respective components of an LCD using a thermogravimetric analyzer (TGA) under controlled humidity. We then measured the coefficients of moisture expansion (CME) of the components using a humiditycontrolled thermomechanical analyzer (TMA). We analyzed the hygromechanical deformations of the respective components, a polarizing plate and an LCD panel using the finite element method (FEM) with measured diffusion coefficients, Henry's law coefficients and the CMEs of the respective components. The analyzed deformations of the respective components corresponded quantitatively with the deformations measured experimentally. However, the analyzed deformation of the polarizing plate did not correspond with the measured deformation perfectly. A polarizing plate is made by sandwiching a polarizer between two sheets of protection film. We ignored the effect of the thin boundary layer between the polarizer and its protecting film in this analysis, and the effect of this boundary layer on the diffusion of moisture may have caused the difference between the analysis and the measurement. The expected warpage of the analyzed LCD corresponded qualitatively with the measured warpage. However, the numerical analyzed strains near the edge of the LCD panel strongly shifted to the compression side compared to the experimental measured strains. A possible reason for this shift was the difference in the boundary condition at the edge of the LCD panel between the numerical analysis and the experimental measurement. The actual edge of the LCD panel was fastened by a bezel, and the contact condition between the LCD panel and the bezel was ambiguous. To perform a quantitative analysis, we will need to investigate the contact condition between the LCD panel and the bezel and introduce it to the numerical analysis. This is left for a future study. We qualitatively investigated the warpage of LCDs with two types of protecting film and different directions of polarizing plates using the developed technique of FEM analysis. | |
