| contributor author | R. A. Masmoudi | |
| contributor author | J. K. Hedrick | |
| date accessioned | 2017-05-08T23:37:54Z | |
| date available | 2017-05-08T23:37:54Z | |
| date copyright | September, 1992 | |
| date issued | 1992 | |
| identifier issn | 0022-0434 | |
| identifier other | JDSMAA-26185#394_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/109944 | |
| description abstract | Current closed-loop automotive shift control algorithms could greatly benefit if a measurement of the drive axle shaft torque was available. Direct measurements using strain gauges are too expensive for commercial applications. Magnetic pickup sensors that count the passage of gear teeth provide very inexpensive RPM measurements and are currently being used in production vehicles. This paper shows through simulations how these sensors can be used with a nonlinear observer technique (sliding mode) to estimate axle shaft torque from measurements of transmission output speed and driven wheel speed. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Estimation of Vehicle Shaft Torque Using Nonlinear Observers | |
| type | Journal Paper | |
| journal volume | 114 | |
| journal issue | 3 | |
| journal title | Journal of Dynamic Systems, Measurement, and Control | |
| identifier doi | 10.1115/1.2897360 | |
| journal fristpage | 394 | |
| journal lastpage | 400 | |
| identifier eissn | 1528-9028 | |
| keywords | Torque | |
| keywords | Vehicles | |
| keywords | Measurement | |
| keywords | Sensors | |
| keywords | Engineering simulation | |
| keywords | Gear teeth | |
| keywords | Strain gages | |
| keywords | Wheels AND Control algorithms | |
| tree | Journal of Dynamic Systems, Measurement, and Control:;1992:;volume( 114 ):;issue: 003 | |
| contenttype | Fulltext | |