Journal of Structural Engineering: Recent submissions
Now showing items 2901-2920 of 10765
-
Experimental Studies on Cyclic Performance of Column Base Strong Axis–Aligned Asymmetric Friction Connections
(American Society of Civil Engineers, 2016)This paper describes experimental testing of an asymmetric friction connection (AFC) at the base of a steel column such as may be used in a moment-frame. Friction/sliding surfaces were parallel to the column-strong axis. ... -
Erratum for “Seismic Response of Rocking Oscillators on a Soft Story: Elastic Response” by Christos Zeris
(American Society of Civil Engineers, 2015) -
Laterally Restrained Bamboo Concrete Composite Arch under Uniformly Distributed Loading
(American Society of Civil Engineers, 2015)The arch, as a structural element, has been used since ancient times, originally in stone or timber, more recently in reinforced concrete or steel. However, the more modern materials involving steel and concrete are highly ... -
Structural Behavior of CHS T-Joints Subjected to Static In-Plane Bending in Fire Conditions
(American Society of Civil Engineers, 2016)Fire resistance of steel joints is always a major concern in the design of steel structures under extremely hazardous conditions. However, for circular hollow section (CHS) joints in fire conditions, little information is ... -
Updating the Assessment of Resistance and Reliability of Existing Aging Bridges with Prior Service Loads
(American Society of Civil Engineers, 2015)The successful past performance of an existing bridge is evidence of its resistance, which reduces the uncertainty associated with the resistance and so increases the bridge reliability. However, the resistance deterioration ... -
Seismic Design Method for CFS Diagonal Strap-Braced Stud Walls: Experimental Validation
(American Society of Civil Engineers, 2016)The search for innovative methods to ensure high structural, technological, and environmental performance is an important issue in the development of new construction. Among the several available building systems, constructions ... -
Push-Off Tests in the Study of Cyclic Behavior of Interfaces between Concretes Cast at Different Times
(American Society of Civil Engineers, 2016)The knowledge about the cyclic behavior and effects of fatigue on interfaces between concrete cast at different times, subjected to shear stress, is still very limited. This aspect is particularly relevant in structures ... -
Quasi-Static Cyclic Testing of Two-Thirds Scale Unbonded Posttensioned Rocking Dissipative Timber Walls
(American Society of Civil Engineers, 2016)Posttensioning low-damage technologies were first developed in the late 1990s as the main outcome of the U.S. Precast Seismic Structural System (PRESSS) program coordinated by the University of California, San Diego, and ... -
Cyclic Loading Test for Exterior Beam–Column Joints of CEFT Columns
(American Society of Civil Engineers, 2016)A cyclic loading test was performed to investigate the seismic performance of exterior beam-column joints of concrete-encased-and-filled steel tubular (CEFT) columns. Two specimens with steel beams and two specimens with ... -
Cyclic Load Tests on Self-Centering Concrete Pier with External Dissipators and Enhanced Durability
(American Society of Civil Engineers, 2016)A precast segmental pier using posttensioning technique has become a desirable candidate to realize rapid, environment-friendly bridge construction and minimal residual deformation. To avoid structural corrosion and to ... -
Novel Sensor Clustering–Based Approach for Simultaneous Detection of Stiffness and Mass Changes Using Output-Only Data
(American Society of Civil Engineers, 2015)This paper presents a novel sensor clustering-based time series approach for anomaly detection. The basic idea of this approach is that localized change in the properties of a structure may affect the relationship between ... -
Experimental Behavior of a Half-Scale Steel Concrete Composite Floor System Subjected To Column Removal Scenarios
(American Society of Civil Engineers, 2016)A half-scale three-bay by three-bay steel-concrete composite floor system, which represented gravity framing for a typical commercial building, was studied experimentally to evaluate its structural integrity under four ... -
Closure to “Novel Sensor Clustering–Based Approach for Simultaneous Detection of Stiffness and Mass Changes Using Output-Only Data” by Qipei Mei and Mustafa Gül
(American Society of Civil Engineers, 2016) -
Discussion of “Novel Sensor Clustering–Based Approach for Simultaneous Detection of Stiffness and Mass Changes Using Output-Only Data” by Qipei Mei and Mustafa Gül
(American Society of Civil Engineers, 2016) -
Out-of-Plane Design Procedure for Confined Masonry Walls
(American Society of Civil Engineers, 2016)This paper presents a design procedure to determine the out-of-plane strength of confined masonry walls. For this purpose, eight full-scale confined walls were tested in the laboratory. Walls were subjected to axial and ... -
Tests to Determine Stress Concentration Factors for Square Bird-Beak SHS Joints under Chord and Brace Axial Forces
(American Society of Civil Engineers, 2014)Bird-beak joints are a type of welded square hollow section (SHS) joint, the static strength of which is higher than that of conventional joints. Experimental analyses were conducted on the stress concentration factors ... -
Cyclic Behavior of CLT Wall Systems: Experimental Tests and Analytical Prediction Models
(American Society of Civil Engineers, 2015)An experimental program was performed at IVALSA Trees and Timber Institute on single and coupled cross-laminated (CLT) wall panels with different anchoring systems and different types of joints between adjacent panels. The ... -
Experimental Investigation of Aluminum Alloy Stub Columns with Circular Openings
(American Society of Civil Engineers, 2015)This paper describes a test program on a wide range of aluminum alloy square hollow section stub columns containing central circular openings. A total of 28 compression tests was conducted by applying uniform axial load ... -
Torsional Behavior of Rectangular and Flanged Concrete Beams with FRP Reinforcements
(American Society of Civil Engineers, 2015)The demand for sustainable future infrastructures calls for new and innovative alternatives to avoid the problems associated with the conventional methods of construction. Fiber-reinforced polymer (FRP) bars have superior ... -
Effect of Concrete Strength and Stud Collar Size to Shear Capacity of Demountable Shear Connectors
(American Society of Civil Engineers, 2015)In this paper, a group of demountable shear connectors have been developed and tested to assess their potential and suitability in terms of replacing welded shear studs. The experiments showed that these demountable shear ...