• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Out-of-Plane Design Procedure for Confined Masonry Walls

    Thumbnail
    View/Open
    46522005.pdf (8.722Mb)
    Date
    2016
    Author
    Joel Moreno-Herrera
    Jorge Varela-Rivera
    Luis Fernandez-Baqueiro
    Metadata
    Show full item record
    Abstract
    This paper presents a design procedure to determine the out-of-plane strength of confined masonry walls. For this purpose, eight full-scale confined walls were tested in the laboratory. Walls were subjected to axial and uniform out-of-plane loads. The variables studied were the unit type and the aspect ratio of the walls. Based on the experimental results, it is observed that as the aspect ratio increases, the out-of-plane strength increases. For walls with the same aspect ratio and failure related to crushing of masonry, the out-of-plane strength depends on the axial compressive strength of masonry. Analytical out-of-plane strength of walls was determined using the bidirectional strut method. This method was validated using experimental results obtained from this and other studies. Failure of wall panel and local failure of concrete confining elements were both included in the design procedure.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/81408
    Collections
    • Journal of Structural Engineering

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV