Journal of Structural Engineering: Recent submissions
Now showing items 1401-1420 of 10765
-
Dynamic Effects on Steel Frames with Concrete Slabs under a Sudden Edge-Column Removal Scenario
(ASCE, 9/1/2020 1)The dynamic effect of structures under column removal scenarios is investigated by conducting comparative experiments on two identical steel frames with concrete slabs. One frame suffers from a static edge-column loss, ... -
Investigation on Postfire Residual Capacity of High-Strength Steel Columns with Axial Restraint
(ASCE, 9/1/2020 1)This paper experimentally and analytically investigates the fire and postfire behavior of axially restrained high-strength steel columns. Tests on the buckling behavior during heating as well as the residual load-bearing ... -
Stiffness and Strength Demands for Pin-Supported Walls in Reinforced-Concrete Moment Frames
(ASCE, 9/1/2020 1)Criteria are proposed for determining the stiffness and strength demands for the seismic design of pin-supported walls in low- and medium-rise reinforced-concrete moment frames. A plasticity ratio and a global stiffness ... -
Comparative and Parametric Studies on Behavior of RC-Flat Plates Subjected to Interior-Column Loss
(ASCE, 9/1/2020 1)To investigate the influence of critical parameters on the progressive collapse resistance of reinforced concrete (RC)-flat plates, a set of finite-element modeling techniques was established. The modeling of bond-slip ... -
Enhanced Seismic Performance of Timber Structures Using Resilient Connections: Full-Scale Testing and Design Procedure
(ASCE, 9/1/2020 1)The innovative resilient slip friction joint (RSFJ) technology has recently been developed and introduced to the construction industry. This technology not only aims to provide life safety for the occupants, but also to ... -
Critical Buckling Strains in Thick Cold-Formed Circular-Hollow Sections under Cyclic Loading
(ASCE, 9/1/2020 1)Contrary to the large dataset of test results exploring the monotonic bending response of steel tubes, the corresponding dataset of cyclic bending tests remains very small. Seven compact and semicompact S355J2H cold-formed ... -
Dynamic Response of Tall Mass-Timber Buildings to Wind Excitation
(ASCE, 10/1/2020 )The use of timber panels to construct the lateral and gravity load resisting systems of tall mass-timber buildings makes them lightweight and less stiff than buildings made from conventional construction materials. As a ... -
PEER Hub ImageNet: A Large-Scale Multiattribute Benchmark Data Set of Structural Images
(ASCE, 10/1/2020 )With the rapid development of machine learning (ML) and deep learning (DL) in computer vision, adopting these learning tools in vision-based structural health monitoring (SHM) and rapid damage assessment is attracting ... -
Examination of Typhoon-Wind Profiles Reaching 1,000-m Height over the Southeast China Sea Based on Reanalysis Data Set and Mesoscale Simulation
(ASCE, 9/1/2020 1)This paper examines the mean wind profiles of tropical cyclones (TCs) toward 1,000-m height with a low-level jet (LLJ) feature over the Southeast China Sea based on the newly released fifth-generation atmospheric reanalysis ... -
Influence of Seismic Design Evolution on the Seismic Collapse Behavior and Losses of Prototype Steel Buildings with Moment-Resisting Frames
(ASCE, 9/1/2020 1)Seismic design provisions for steel moment frame buildings have undergone substantial changes over the past half century. Despite the anticipated benefits of enforcing newer codes, it is not yet fully known how the evolution ... -
Behavior, Failure, and Direct Strength Method Design of Steel Angle Columns: Geometrical Simplicity versus Structural Complexity
(ASCE, 11/1/2020 )This work provides a state-of-the-art report on the current knowledge concerning the structural behavior and design, by means of the Direct Strength Method (DSM), of steel equal-leg angle columns with short-to-intermediate ... -
Probabilistic Approach to Account for Soil-Structure Interaction in Seismic Design of Building Structures
(ASCE, 9/1/2020 1)This paper proposes a novel probabilistic approach to account for soil-structure interaction (SSI) in the seismic design of building structures. In this approach, an SSI response modification factor, RSSI, is introduced ... -
Local Vibration Testing and Damage Evaluation for RC Bridge Decks
(ASCE, 9/1/2020 1)The effectiveness of local (through-thickness) vibration testing, using a portable vibrator, is examined for determining damage locations and conditions within reinforced concrete (RC) bridge decks. The local vibration ... -
Shaking Table Test of Seismic Isolated Structures with Sliding Hydromagnetic Bearings
(ASCE, 9/1/2020 1)The sliding hydromagnetic bearing is a low-friction isolator proposed in recent years. Its novelty lies in adaptive energy dissipation and alterable deflection constraint, which has been demonstrated by previous studies ... -
Tensile Tests of Cold-Formed Stainless Steel Tubes
(ASCE, 9/1/2020 1)In this study, an experimental program on cold-formed stainless steel tubular sections with and without perforations under pure tension is presented. Nine cross section series made of ferritic, lean duplex, and austenitic ... -
Elevated Temperature Effects on Performance of a Cross-Laminated Timber Floor-to-Wall Bracket Connections
(ASCE, 9/1/2020 1)Connections in mass timber structural systems transfer lateral forces from mass timber elements such as shear walls to floor diaphragms. Cross-laminated timber (CLT) is a prominent engineered mass timber material used to ... -
Uncoupled Compression Membrane Analysis of Reinforced-Concrete Members Subject to Extreme Loads
(ASCE, 9/1/2020 1)An analytical procedure was developed to predict the compression membrane behavior of laterally restrained reinforced concrete members subject to extreme loads, such as those generated by the loss of bearing elements or ... -
Rocking Response of Unanchored Building Contents Considering Horizontal and Vertical Excitation
(ASCE, 9/1/2020 1)The seismic performance of unanchored slender contents at various floor levels within a building has received little attention in the literature, despite earthquake reconnaissance reports routinely emphasizing the overturning ... -
Mechanics-Guided Genetic Programming Expression for Shear-Strength Prediction of Squat Reinforced Concrete Walls with Boundary Elements
(ASCE, 11/1/2020 )Squat reinforced concrete shear walls with boundary elements (SRCSW-BE) are used in special structures (e.g., nuclear facilities) to resist lateral seismic loads. However, several studies have demonstrated the inaccuracy ... -
Decay of Torsional Stiffness in RC U-Shaped Walls
(ASCE, 9/1/2020 1)Reinforced concrete (RC) U-shaped walls are a popular construction choice, commonly used to resist the lateral loads from wind and earthquakes. In many buildings, the center of stiffness of a floor is eccentric from the ...