Evaluation of Thermal Performance of Conically Shaped Micro Helical Tubes Using Non-Newtonian Nanofluids–A Numerical Study

Abstract

Nowadays, the cooling and heating of micro-thermal devices have received a growing interest. To improve the thermal management of these micro-thermal devices, various efforts are being made by the researchers. In the present study, conically shaped micro helical tubes are used to investigate the coil side heat transfer rate and friction factor of non-Newtonian nanofluids under laminar flow conditions. For the numerical analysis, single-phase approach with commercial software ansys-fluent-19 has been utilized. Investigations encompass generalized Reynold numbers ranging from 306 to 2159 and four different curvature ratios (0.066, 0.076, 0.088, and 0.1) of conically shaped micro helical tubes. The inner diameter of the helical tube is 2 mm and contains 20 turns. Al2O3-based non-Newtonian nanofluids with volume concentrations of 0.0%, 0.1%, and 0.2% having base fluid of aqueous solution of carboxymethyl-cellulose (CMC) are used as the working fluid (hot) for the coil side, while in the shell side cold water is used. The results from numerical investigation are validated and found in good agreement with earlier experimental results. The results show that with the increase in the curvature ratio of conically coiled tubes both heat transfer rate and friction factor increase by 46% and 98% respectively, for base fluid at a curvature ratio of 0.1. Also, the present study reveals that adding nanoparticles to the base fluid enhances the heat transfer rate to a maximum value of 40%. Moreover, the maximum value of thermal performance factor (TPF) is found to be 1.52.