Structural and Rotordynamic Force Coefficients of a Shimmed Bump Foil Bearing: An Assessment of a Simple Engineering Practice

Abstract

High speed rotors supported on bumptype foil bearings (BFBs) often suffer from large subsynchronous whirl motions. Mechanically preloading BFBs through shimming is a common, low cost practice that shows improvements in rotordynamic stability. However, there is an absence of empirical information related to the force coefficients (structural and rotordynamic) of shimmed BFBs. This paper details a concerted study toward assessing the effect of shimming on a first generation BFB (L = 38.1 mm and D = 36.5 mm). Three metal shims, 120 deg apart, are glued to the inner surface of the bearing cartridge and facing the underside of the bump foil strip. The shim sets are of identical thickness, either 30 خ¼m or 50 خ¼m. In static load tests, a bearing with shims shows a (nonlinear) structural stiffness larger than for the bearing without shims. Torque measurements during shaft acceleration also demonstrate a shimmed BFB has a larger friction coefficient. For a static load of 14.3 kPa, dynamic loads with a frequency sweep from 250 Hz to 450 Hz are exerted on the BFB, without and with shims, to estimate its rotordynamic force coefficients while operating at ∼50 krpm (833 Hz). Similar measurements are conducted without shaft rotation. Results are presented for the original BFB (without shims) and the two shimmed BFB configurations. The direct stiffnesses of the BFB, shimmed or not, increase with excitation frequency, thus evidencing a mild hardening effect. The BFB stiffness and damping coefficients decrease slightly for operation with rotor speed as opposed to the coefficients when the shaft is stationary. For frequencies above 300 Hz, the direct damping coefficients of the BFB with 50 خ¼m thick shims are ∼30% larger than the coefficients of the original bearing. The bearing structural loss factor, a measure of its ability to dissipate mechanical energy, is derived from the direct stiffness and damping coefficients. The BFB with 50 خ¼m thick shims has a 25% larger loss factor—average from test data collected at 300 Hz to 400 Hz—than the original BFB. Further measurements of rotor motions while the shaft accelerates to ∼50 krpm demonstrate the shimmed BFB (thickest shim set) effectively removes subsynchronous whirl motions amplitudes that were conspicuous when operating with the original bearing.