Effects of Inlet Turbulence and End Wall Boundary Layer on Aerothermal Performance of a Transonic Turbine Blade Tip

Abstract

Most of the previous researches of inlet turbulence effects on blade tip have been carried out for low speed situations. Recent work has indicated that for a transonic turbine tip, turbulent diffusion tends to have a distinctively different impact on tip heat transfer than for its subsonic counterpart. It is hence of interest to examine how inlet turbulence flow conditioning would affect heat transfer characteristics for a transonic tip. The present work is aimed to identify and understand the effects of both inlet freestream turbulence and end wall boundary layer on a transonic turbine blade tip aerothermal performance. Spatiallyresolved heat transfer data are obtained at aerodynamic conditions representative of a highpressure turbine, using the transient infrared thermography technique with the Oxford HighSpeed Linear Cascade research facility. With and without turbulence grids, the turbulence levels achieved are 7%–9% and 1%, respectively. On the blade tip surface, no apparent change in heat transfer was observed with high and low inlet turbulence intensity levels investigated. On the blade suction surface, however, substantially different local heat transfer distributions for the suction side near tip surface have been observed, indicating a strong local dependence of the local vortical flow structure on the freestream turbulence. These experimentally observed trends have also been confirmed by CFD examinations using the RollsRoyce HYDRA. A further CFD analysis suggests that the level of inflow turbulence alters the balance between the passage vortex associated secondary flow and the over tip leakage (OTL) flow. Consequently, an enhanced inertia of near wall fluid at a higher inflow turbulence weakens the crosspassage flow. As such, the weaker passage vortex leads the tip leakage vortex to move further into the mid passage, with the less spanwise coverage on the suction surface, as consistently indicated by the heat transfer signature. Different inlet end wall boundary layer profiles are employed in the computational study with HYDRA. All CFD results indicate the inlet boundary layer thickness has little impact on the heat transfer over the tip surface as well as the pressure side neartip surface. However, noticeable changes in heat transfer are observed for the suction side neartip surface. Similar to the inlet turbulence effect, such changes can be attributed to the interaction between the passage vortex and the OTL flow.