Optimization of Multistage Machining System: Analysis of Optimal Machining Conditions for the Flow-Type Machining SystemSource: Journal of Manufacturing Science and Engineering:;1971:;volume( 093 ):;issue: 002::page 498Author:K. Hitomi
DOI: 10.1115/1.3427957Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A fundamental mathematical model for the flow-type multistage machining system was built in an attempt to determine optimum machining conditions to be set on production stages. Based upon three kinds of evaluation criteria, i.e., the maximum production rate, the minimum production cost, and the maximum profit rate, the optimal cutting speeds to be set on production stages and the optimal cycle time for the multistage machining system were theoretically analyzed, and the computational procedure for obtaining them was developed. The computer program was also prepared and used to solve typical examples of optimzation of the multistage machining system.
keyword(s): Flow (Dynamics) , Machining , Systems analysis , Optimization , Computer software , Cutting AND Cycles ,
|
Collections
Show full item record
| contributor author | K. Hitomi | |
| date accessioned | 2017-05-09T01:06:13Z | |
| date available | 2017-05-09T01:06:13Z | |
| date copyright | May, 1971 | |
| date issued | 1971 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27561#498_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/154267 | |
| description abstract | A fundamental mathematical model for the flow-type multistage machining system was built in an attempt to determine optimum machining conditions to be set on production stages. Based upon three kinds of evaluation criteria, i.e., the maximum production rate, the minimum production cost, and the maximum profit rate, the optimal cutting speeds to be set on production stages and the optimal cycle time for the multistage machining system were theoretically analyzed, and the computational procedure for obtaining them was developed. The computer program was also prepared and used to solve typical examples of optimzation of the multistage machining system. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Optimization of Multistage Machining System: Analysis of Optimal Machining Conditions for the Flow-Type Machining System | |
| type | Journal Paper | |
| journal volume | 93 | |
| journal issue | 2 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.3427957 | |
| journal fristpage | 498 | |
| journal lastpage | 506 | |
| identifier eissn | 1528-8935 | |
| keywords | Flow (Dynamics) | |
| keywords | Machining | |
| keywords | Systems analysis | |
| keywords | Optimization | |
| keywords | Computer software | |
| keywords | Cutting AND Cycles | |
| tree | Journal of Manufacturing Science and Engineering:;1971:;volume( 093 ):;issue: 002 | |
| contenttype | Fulltext |