Inlet Fogging of Gas Turbine Engines: Climatic Analysis of Gas Turbine Evaporative Cooling Potential of International Locations

Abstract

Inlet fogging of gas turbine engines has attained considerable popularity due to the ease of installation and the relatively low first cost compared to other inlet cooling methods. With increasing demand for power and with shortages envisioned especially during the peak load times during the summers, there is a need to boost gas turbine power. There is a sizable evaporative cooling potential throughout the world when the climatic data is evaluated based on an analysis of coincident wet bulb and dry bulb information. These data are not readily available to plant users. In this paper, a detailed climatic analysis is made of 106 major locations over the world to provide the hours of cooling that can be obtained by direct evaporative cooling. This data will allow gas turbine operators to easily make an assessment of the economics of evaporative fogging. The paper also covers an introduction to direct evaporative cooling and the methodology and data analysis used to derive the cooling potential. Simulation runs have been made for gas turbine simple cycles showing effects of fogging for a GE Frame 7EA and a GE Frame 9FA Gas turbine for 60 and 50 Hz applications.