• Login
    View Item 
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    •   DSpace Home
    • ASCE
    • Journal of Structural Engineering
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Chord Sidewall Failure of RHS X-Joints in Compression and Associated Design Recommendations

    Thumbnail
    View/Open
    %28ASCE%29ST.1943-541X.0003068.pdf (5.032Mb)
    Date
    8/1/2021
    Author
    Seon-Hu Kim
    Cheol-Ho Lee
    Metadata
    Show full item record
    Abstract
    In this study, the behavior of rectangular hollow-section (RHS) X-joints in compression is investigated, with a focus on the failure mode of chord sidewall failure, which is more likely to occur when the brace-to-chord width ratio is close to 1.0. For joints with a width ratio of 1.0 (or full-width joints), the test-backed numerical analysis in this study clearly indicated that sidesway instability could readily occur even if sufficient out-of-plane restraint is provided. The sidesway instability was found to considerably impair the ultimate strength of full-width joints. A new borderline width ratio is proposed, beyond which the chord face plastification and chord sidewall failure limit states start to interact and should be considered simultaneously in the joint design. This investigation was motivated by a previous experimental observation, wherein the failure mode of the tested joints with a borderline width ratio of 0.85 as per current design standards was essentially the less ductile chord sidewall buckling observed in full-width joints. Based on simple mechanics, an analytical and more rational expression for the borderline width ratio is derived and validated in this study. After existing formulas for the chord sidewall strength were thoroughly reviewed and all the findings and developments were collated, an improved design recommendation that can cover high-strength steels whose yield stress is as high as 700 MPa is suggested for RHS X-joints under brace axial compression.
    URI
    http://yetl.yabesh.ir/yetl1/handle/yetl/4270440
    Collections
    • Journal of Structural Engineering

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV