Show simple item record

dc.contributor.authorSeon-Hu Kim
dc.contributor.authorCheol-Ho Lee
dc.date.accessioned2022-01-31T23:50:17Z
dc.date.available2022-01-31T23:50:17Z
dc.date.issued8/1/2021
dc.identifier.other%28ASCE%29ST.1943-541X.0003068.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4270440
dc.description.abstractIn this study, the behavior of rectangular hollow-section (RHS) X-joints in compression is investigated, with a focus on the failure mode of chord sidewall failure, which is more likely to occur when the brace-to-chord width ratio is close to 1.0. For joints with a width ratio of 1.0 (or full-width joints), the test-backed numerical analysis in this study clearly indicated that sidesway instability could readily occur even if sufficient out-of-plane restraint is provided. The sidesway instability was found to considerably impair the ultimate strength of full-width joints. A new borderline width ratio is proposed, beyond which the chord face plastification and chord sidewall failure limit states start to interact and should be considered simultaneously in the joint design. This investigation was motivated by a previous experimental observation, wherein the failure mode of the tested joints with a borderline width ratio of 0.85 as per current design standards was essentially the less ductile chord sidewall buckling observed in full-width joints. Based on simple mechanics, an analytical and more rational expression for the borderline width ratio is derived and validated in this study. After existing formulas for the chord sidewall strength were thoroughly reviewed and all the findings and developments were collated, an improved design recommendation that can cover high-strength steels whose yield stress is as high as 700 MPa is suggested for RHS X-joints under brace axial compression.
dc.publisherASCE
dc.titleChord Sidewall Failure of RHS X-Joints in Compression and Associated Design Recommendations
dc.typeJournal Paper
dc.journal.volume147
dc.journal.issue8
dc.journal.titleJournal of Structural Engineering
dc.identifier.doi10.1061/(ASCE)ST.1943-541X.0003068
dc.journal.fristpage04021111-1
dc.journal.lastpage04021111-23
dc.page23
dc.treeJournal of Structural Engineering:;2021:;Volume ( 147 ):;issue: 008
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record