Journal of Energy Resources Technology: Recent submissions
Now showing items 3161-3180 of 3450
-
Freezing and Thawing: Heat Balance Integral Approximations
(The American Society of Mechanical Engineers (ASME), 1983)The study of conductive heat transfer with phase change — often called the Stefan problem — includes some of the most intractable mathematical areas of heat transfer. Exact solutions are ... -
Energy Recovery From Refuse in the Kiel District Heating Station
(The American Society of Mechanical Engineers (ASME), 1983)The Kiel resource recovery facility proves that dependable waste disposal service can be combined with efficient energy recovery. During the first 8 yr of continuous operation, approximately ... -
Thermal Performance Evaluation of MSW-Fired Steam Generators—A New Approach
(The American Society of Mechanical Engineers (ASME), 1983)Determination of thermal performance or efficiency of steam generators by traditional ASME procedures is a complex and difficult undertaking. When the fuel is municipal solid waste, additional ... -
Discussion: “A Facility and Approach to Performance Test of Check Valves” (Collier, S. L., and Hoerner, C. C., 1983, ASME J. Energy Resour. Technol., 105, pp. 62–66)
(The American Society of Mechanical Engineers (ASME), 1983) -
A Rate-Dependent Stress-Strain Relationship for Sea Ice
(The American Society of Mechanical Engineers (ASME), 1983)A one-dimensional rate-sensitive stress-strain relationship is developed to describe the uniaxial mechanical behavior in compression for sea ice. It is a one-term, nonlinear model and is simpler ... -
The Trans-Alaska Pipeline System Synthetically Insulated Workpad—An Evaluation of Present Conditions
(The American Society of Mechanical Engineers (ASME), 1983)The purpose of the insulated workpad study, described in the following paper, was twofold. First, the owners of the Trans-Alaska Pipeline System (TAPS) needed an evaluation of present conditions ... -
An Analysis of the Thermal Fixation of Pilings
(The American Society of Mechanical Engineers (ASME), 1983)Pilings, fixed in place with frozen sand-water fill, are used as foundations in regions of the world where the ground is permanently frozen. The heat transfer processes in the piling-fill-gro ... -
Ice Force Prediction Using a Limited Driving Force Approach
(The American Society of Mechanical Engineers (ASME), 1983)This paper discusses the importance of environmental driving forces in determining ice loads on Arctic offshore structures. Limits to the environmental driving force in a first-year ice field ... -
Floating Ice Road Construction
(The American Society of Mechanical Engineers (ASME), 1983)During the winter of 1980–81, Exxon built about 16 km of floating ice roads in the Beaufort Sea off the north slope of Alaska. These roads were used to haul gravel and other materials for ... -
Reliability Analysis of Total Systems Using Component Failure Data
(The American Society of Mechanical Engineers (ASME), 1983)Assessment of total system reliability has been accomplished using component failure data in conjunction with system operating rules and sparing policies. This paper describes the computer simulation ... -
A Reliability Based Fatigue Damage Theory for Safe Design
(The American Society of Mechanical Engineers (ASME), 1983)A reasonably safe reliability approach to a fatigue damage theory can be based on the fact that, in most cases involving the public safety, the designer can accept only very low probabilities ... -
Energy Losses due to Limit-Cycle Behavior of a Large Tanker Under Automatic Steering Control
(The American Society of Mechanical Engineers (ASME), 1983)The problem of limit-cycle behavior of a 250,000-dwt tanker in full-load and ballast conditions under automatic steering control in calm water is addressed. The approach presented involves digital ... -
Fatigue Tests and Design of Offshore Tubular Joints
(The American Society of Mechanical Engineers (ASME), 1983)The AWS-X “hotspot stress-load cycle” curve used at present for designing tubular joints is based mainly on the fillet-welded plate test data and some more data from small-scale tests on tubular ... -
Fatigue Strength of Welded Tubular T Joints Under Variable Amplitude Loading
(The American Society of Mechanical Engineers (ASME), 1983)This paper describes an experimental study on fatigue strength of welded tubular T joints, performed in small and large-scale models fabricated from mild steel tubes. Fatigue tests were conducted ... -
Stresses in Stiffened Tubular T Joint of an Offshore Structure
(The American Society of Mechanical Engineers (ASME), 1983)The effect of internal ring stiffeners has been studied theoretically and experimentally for the welded tubular T joints occurring in conventional jacket-type offshore structures. Four welded ... -
Underground Coal Gasification Research
(The American Society of Mechanical Engineers (ASME), 1983)Recent successful field tests of underground coal gasification, UCG, have demonstrated the potential for UCG commercialization. This paper presents results of mathematical modeling and laboratory ... -
The Fatigue Behavior of Large-Scale As-Welded and Stress-Relieved Tubular T Joints
(The American Society of Mechanical Engineers (ASME), 1983)The changing strain distribution within large-scale tubular T joints, subjected to fully reversed axial brace fatigue loading, were measured in as-welded and stress-relieved conditions. Initial ... -
Shallow Magnetic Induction Measurements for Delineating Near-Surface Hot Groundwater Sources in Alaskan Geothermal Areas
(The American Society of Mechanical Engineers (ASME), 1983)Variations in the electrical conductivity of a soil and water system with temperature and salt concentration suggest that a soil containing hot and/or saline groundwater may be expected to have ... -
Geothermal District Heating Using Existing Potable Water Piping Systems
(The American Society of Mechanical Engineers (ASME), 1983) -
A Side Wall Burn Model for Cavity Growth in Underground Coal Gasification
(The American Society of Mechanical Engineers (ASME), 1983)A mechanistic computer model is presented which predicts the 3-D cavity growth during the gasification phase of underground coal gasification. Developed for swelling bituminous coals, the model ...