Journal of Energy Resources Technology: Recent submissions
Now showing items 1401-1420 of 3450
-
Measurements of Hydrogen-Enriched Combustion of JP-8 in Open Flame
(The American Society of Mechanical Engineers (ASME), 2017)Hydrogen enrichment is presented as a control parameter to improve JP-8 combustion. Research in fuel reforming gives an opportunity for hydrogen production at the point of use. Hydrogen-enriched combustion of JP-8 seeks ... -
Effects of Damköhler Number on Methane/Oxygen Tubular Combustion Diluted by N2 and CO2
(The American Society of Mechanical Engineers (ASME), 2017)To fundamentally elucidate the mixing and its effects on the characteristics of methane/oxygen flame in a rapidly mixed tubular flame burner, experiments were conducted under various oxygen mole fractions and flow rates. ... -
A New Approach for Model-Based Monitoring of Turbine Heat Rate
(The American Society of Mechanical Engineers (ASME), 2017)In this paper, a new approach for model-based monitoring of turbine heat rate is developed, where the superheat steam flow is calculated according to the output power of the turbine generation instead of the flow of feed ... -
Pro-Ecological Exergy Tax of Electricity
(The American Society of Mechanical Engineers (ASME), 2016)The concept of the pro-ecological tax or support is proposed in this article. It could replace the existing subsidy mechanisms for renewable power technology or could represent the ecological taxes burdening the fabrication ... -
Special Issue Dedicated to the 28th International Conference on Efficiency, Cost, Optimization, Simulation, and Environmental Impact of Energy Systems (ECOS 2015)
(The American Society of Mechanical Engineers (ASME), 2016) -
Performance Study and Energy Saving Process Analysis of Hybrid Absorption-Compression Refrigeration Cycles
(The American Society of Mechanical Engineers (ASME), 2016)In an attempt to improve the performance of hybrid absorption and mechanical vapor compression refrigeration systems and to determine the fundamental reasons for such improvements, two configurations of the hybrid refrigeration ... -
CO2 Emissions Reduction From Coal-Fired Power Generation: A Techno-Economic Comparison
(The American Society of Mechanical Engineers (ASME), 2016)Carbon capture and storage (CCS) represents a key solution to control the global warming reducing carbon dioxide emissions from coal-fired power plants. This study reports a comparative performance assessment of different ... -
Thermo-Economic Evaluation of Novel Flexible CAES/CCPP Concept
(The American Society of Mechanical Engineers (ASME), 2017)This paper presents the results of a thermodynamic and economic evaluation of a novel hybrid combination of a compressed air energy storage (CAES) and a combined cycle power plant (CCPP). The new cycle is modeled on the ... -
Energy Conservation Via Greywater Reuse for Power Plant Cooling and Wastes Minimization
(The American Society of Mechanical Engineers (ASME), 2016)Sustainable engineering brings about multidisciplinary solutions to environmental, sociocultural, and economic needs. Sustainable methods and technologies ensure the effectiveness of products, designs, and infrastructure, ... -
Thermodynamic Analysis of Simultaneous Heat and Mass Transfer Systems
(The American Society of Mechanical Engineers (ASME), 2016)The direct heat exchange network (direct flow mixing network) and the indirect heat exchange network (exchanger network) are two of the elements that constitute a water network where heat and mass are transferred. When ... -
Numerical Investigation on the Effects of Flame Propagation in Rotary Engine Performance With Leakage and Different Recess Shapes Using Three Dimensional Computational Fluid Dynamics
(The American Society of Mechanical Engineers (ASME), 2016)This study was carried out with an objective to develop a 3D simulation methodology for rotary engine combustion study and to investigate the effect of recess shapes on flame travel within the rotating combustion chamber ... -
Special Issue: Selected Papers From the 40th International Technical Conference on Clean Coal and Fuel Systems
(The American Society of Mechanical Engineers (ASME), 2016)The special issue contains selected papers presented at the 40th International Technical Conference on Clean Coal and Fuel Systems. The conference was held at the Sheraton Sand Keys Hotel, Clearwater, FL during May 31–June ... -
Measurements of Laminar Flame Speeds of Gas to Liquid Diesel Fuel Blends
(The American Society of Mechanical Engineers (ASME), 2016)This work investigates the laminar flame speed, SN, of gastoliquid (GTL) fuel and its 50–50% by volume blends with conventional diesel, in a cylindrical bomb capable of measuring SN at different initial temperatures and ... -
Mechanical Efficiency of Hydraulic Air Compressors
(The American Society of Mechanical Engineers (ASME), 2016)After air and water mixing, the process of gas compression in the downcomer shaft or pipe of a hydraulic air compressor is considered nearly isothermal due to (i) the mass flow rate of water being typically of three orders ... -
Modeling of a Refrigerator in Disaster Vehicle, Using Solar Energy and Engine Exhaust Gases Heat
(The American Society of Mechanical Engineers (ASME), 2016)In critical situations such as floods and earthquakes, the relief forces require a refrigeration for pharmaceuticals and vaccines, which could operate without an electrical energy and the alternative energies, such as solar ... -
Optimal Design and Control of Wind Diesel Hybrid Energy Systems for Remote Arctic Mines
(The American Society of Mechanical Engineers (ASME), 2016)Mining operations are located in increasingly remote areas in order to search for relatively highgrade mineral deposits, despite the challenges that arise. These challenges are fundamentally logistic and directly impact ... -
Experimental Study on In Cylinder Pressure Oscillations of Homogenous Charge Compression Ignition–Direct Injection Combustion Engine Fueled With Dimethyl Ether
(The American Society of Mechanical Engineers (ASME), 2016)The incylinder pressure oscillations of a homogeneous charge compression ignition (HCCI)DI engine fueled with dimethyl ether (DME) have been investigated using discrete wavelet transform (DWT) based on four different wavelet ... -
Dynamic Model of a Vortex Induced Energy Converter
(The American Society of Mechanical Engineers (ASME), 2016)Vortexinduced energy converters (VIECs) are attracting the attention of researchers looking for energyharvesting systems in the marine environment. These energy converters, while probably less efficient than many other ... -
Diesoline, Diesohol, and Diesosene Fuelled HCCI Engine Development
(The American Society of Mechanical Engineers (ASME), 2016)Compression ignition (CI) engines are facing strong restrictive emission norms globally, which demand extremely low oxides of nitrogen (NOx) and particulate matter (PM) emissions. Homogeneous charge compression ignition ... -
Cooling of Turbine Blade Surface With Expanded Exit Holes: Computational Suction Side Analysis
(The American Society of Mechanical Engineers (ASME), 2016)Turbine blade surfaces are cooled by jet flow from expanded exit holes (EEHs) against the prevailing hot gas flow. The flow through EEH must be designed to form a film of cool air over the blade. Computational analyses are ...