Journal of Energy Resources Technology: Recent submissions
Now showing items 1061-1080 of 3450
-
Absorption Process in MgCl2–NH3 Thermochemical Batteries With Constant Mass Flow Rate
(The American Society of Mechanical Engineers (ASME), 2019)In this paper, the performance of a thermochemical battery based on magnesium chloride and ammonia pair with a constant mass flow rate of ammonia gas is studied through a series of experiments using single and multicell ... -
Demographical Energy Usage Analysis of Residential Buildings
(The American Society of Mechanical Engineers (ASME), 2019)Residential energy consumption constitutes a significant portion of the overall energy consumption. There are significant amount of studies that target to reduce this consumption, and these studies mainly create mathematical ... -
Fuel Cell Backup Power System for Grid Service and Microgrid in Telecommunication Applications
(The American Society of Mechanical Engineers (ASME), 2019)This paper presents the feasibility and economics of using fuel cell backup power systems in telecommunication cell towers to provide grid services (e.g., ancillary services, demand response (DR)) as well as power for cell ... -
Enhanced Ground Source Heat Pump System With Thermal Storage System
(The American Society of Mechanical Engineers (ASME), 2019)The short-cycling operation of a heat pump decreases energy consumption efficiency. Short-cycling operations of ground source heat pump system (GSHP) occur when the ON/OFF control of a heat pump is used in a partial load ... -
Study on Optimization of Pressure Ratio Distribution in Multistage Compressed Air Energy Storage System
(The American Society of Mechanical Engineers (ASME), 2019)In this study, the round trip efficiency of a multistage adiabatic compressed air energy storage (A-CAES) system was optimized by differential evolution (DE) algorithm, and decision variables were the pressure ratio of ... -
A Simple Palladium Hydride Embedded Atom Method Potential for Hydrogen Energy Applications
(The American Society of Mechanical Engineers (ASME), 2019)When hydrogen is produced from a biomass or coal gasifier, it is necessary to purify it from syngas streams containing components such as CO, CO2, N2, CH4, and other products. Therefore, a challenge related to hydrogen ... -
A Novel Vibration Suppression Device for Floating Offshore Wind Generator
(The American Society of Mechanical Engineers (ASME), 2019)With the increasing demand for clean energy, offshore wind power is developing rapidly. But compared to onshore situation, the working environment at sea is very complicated. In order to ensure the stable operation of ... -
Definition and Interpretation of Wind Farm Efficiency in Complex Terrain: A Discussion
(The American Society of Mechanical Engineers (ASME), 2019)The exploitation of wind turbines in complex terrain has recently been growing. The comprehension of wind flow, especially in the downstream area, is by itself a challenging task in complex terrain: even more so, it is ... -
Precision Computation of Wind Turbine Power Upgrades: An Aerodynamic and Control Optimization Test Case
(The American Society of Mechanical Engineers (ASME), 2019)Wind turbine upgrades have recently been spreading in the wind energy industry for optimizing the efficiency of the wind kinetic energy conversion. These interventions have material and labor costs; therefore, it is ... -
Design and Optimization of Composite Offshore Wind Turbine Blades
(The American Society of Mechanical Engineers (ASME), 2019)In order to obtain an optimal design of composite offshore wind turbine blade, take into account all the structural properties and the limiting conditions applied as close as possible to real cases. This work is divided ... -
Specific Entropy Generation in a Gas Turbine Power Cycle
(The American Society of Mechanical Engineers (ASME), 2018)Numerous studies have shown that the minimization of entropy generation does not always lead to an optimum performance in energy conversion systems. The equivalence between minimum entropy generation and maximum power ... -
Impact of Hydrophobicity of SiO2 Nanoparticles on Enhancing Properties of Colloidal Gas Aphron Fluids: An Experimental Study
(The American Society of Mechanical Engineers (ASME), 2018)In recent years, colloidal gas aphron (CGA) fluids have been much attended by researchers for their possible application in infill drilling, due to their pore blockage ability. In this study, the possible synergistic effect ... -
Pressure-Transient Behavior of Multisegment Horizontal Wells With Nonuniform Production: Theory and Case Study
(The American Society of Mechanical Engineers (ASME), 2018) -
Investigation on Di-(2-Methoxypropyl) Carbonate Used as a Clean Oxygenated Fuel for Diesel Engine
(The American Society of Mechanical Engineers (ASME), 2018)Utilization of oxygenated fuels has proven to be able to significantly control diesel engine exhaust emissions. Presented in this paper is a new oxygenated fuel di-(2-methoxypropyl) carbonate (DMPC), which was produced ... -
Multi-Objective Optimization Model Development to Support Sizing Decisions for a Novel Reciprocating Steam Engine Technology
(The American Society of Mechanical Engineers (ASME), 2018)A system-level computational model of a recently patented and prototyped novel steam engine technology was developed from first principles for the express purpose of performing design optimization studies for the engine's ... -
Special Issue: Selected Papers From the 42th International Technical Conference on Clean Coal and Fuel Systems
(The American Society of Mechanical Engineers (ASME), 2018)ecial issue contains selected papers presented at the 42nd International Clearwater Clean Energy Conference. The conference was held at the Sheraton Sand Keys Hotel, Clearwater, FL during June 11–15, 2017. The endorsing ... -
Capturing Pressure Oscillations in Numerical Simulations of Internal Combustion Engines
(The American Society of Mechanical Engineers (ASME), 2018)In an earlier publication (Jupudi et al., 2016, “Application of High Performance Computing for Simulating Cycle-to-Cycle Variation in Dual-Fuel Combustion Engines,” SAE Paper No. 2016-01-0798), the authors compared numerical ... -
Study on Fracture Initiation Mechanisms of Hydraulic Refracturing Guided by Directional Boreholes
(The American Society of Mechanical Engineers (ASME), 2018)In order to generate a new fracture far away from the original fracture in refracturing and effectively enhancing productivity, the technology of hydraulic refracturing guided by directional boreholes was presented. The ... -
Experimental Investigation on Damage Mechanism of Guar Gum Fracturing Fluid to Low-Permeability Reservoir Based on Nuclear Magnetic Resonance
(The American Society of Mechanical Engineers (ASME), 2018)The damage mechanism of fracturing fluids has always been the hot research topic in the development of low-permeability reservoir with hydraulic fracturing. At present, the research in this area is conducted mostly by the ... -
Insights of Wormhole Propagation During Carbonate Acidizing: A Comparison Between Constant Injection Pressure Versus Constant Volumetric Rate
(The American Society of Mechanical Engineers (ASME), 2018)Acidizing of carbonate reservoirs is a common technique used to restore and enhance production by dissolving a small fraction of the rock to create highly conductive channels. Literature review reveals that most acidizing ...