Journal of Heat Transfer: Recent submissions
Now showing items 3541-3560 of 3611
-
Forced Convective Heat Transfer in Parallel Flow Multilayer Microchannels
(The American Society of Mechanical Engineers (ASME), 2007)In this paper, the effect of increasing the number of layers on improving the thermal performance of microchannel heat sinks is studied. In this way, both numerical and analytical methods are ... -
Laminar Mixed Convection in the Entrance Region of Horizontal Semicircular Ducts With the Flat Wall at the Top
(The American Society of Mechanical Engineers (ASME), 2007)Laminar mixed convection in the entrance region for horizontal semicircular ducts with the flat wall on top is investigated theoretically. The governing momentum and energy equations are solved ... -
Local Heat Transfer Coefficients Induced by Piezoelectrically Actuated Vibrating Cantilevers
(The American Society of Mechanical Engineers (ASME), 2007)Piezoelectric fans have been shown to provide substantial enhancements in heat transfer over natural convection while consuming very little power. These devices consist of a piezoelectric material ... -
Forced Convection Heat Transfer and Hydraulic Losses in Graphitic Foam
(The American Society of Mechanical Engineers (ASME), 2007)Experiments and computations are presented to quantify the convective heat transfer and the hydraulic loss that is obtained by forcing water through blocks of graphitic foam (GF) heated from ... -
Temperature-Dependent Viscosity and Viscous Dissipation Effects in Simultaneously Developing Flows in Microchannels With Convective Boundary Conditions
(The American Society of Mechanical Engineers (ASME), 2007)The effects of viscous dissipation and temperature dependent viscosity in simultaneously developing laminar flows of liquids in straight microchannels are studied with reference to convective ... -
Convective Heat Transfer in Open Cell Metal Foams
(The American Society of Mechanical Engineers (ASME), 2007)Convective heat transfer in aluminum metal foam sandwich panels is investigated with potential applications to actively cooled thermal protection systems in hypersonic and re-entry vehicles. The ... -
Dual Solutions in Magnetohydrodynamic Mixed Convection Flow Near a Stagnation-Point on a Vertical Surface
(The American Society of Mechanical Engineers (ASME), 2007)The steady magnetohydrodynamic (MHD) mixed convection stagnation-point flow toward a vertical heated surface is investigated in this study. The external velocity impinges normal to the vertical ... -
Laser Transmission Welding of a Lap-Joint: Thermal Imaging Observations and three–dimensional Finite Element Modeling
(The American Society of Mechanical Engineers (ASME), 2007)Laser transmission welding (LTW) is a relatively new technology for joining plastic parts. This paper presents a three-dimensional (3D) transient thermal model of LTW solved with the finite ... -
The Error Analysis of a Steady-State Thermal Conductivity Measurement Method With Single Constant Temperature Region
(The American Society of Mechanical Engineers (ASME), 2007)A method for steady-state thermal conductivity measurement with single constant temperature region has been developed. To better understand the accuracy of the method a numerical model is devised ... -
Developing Turbulent Forced Convection in Two-Dimensional Duct
(The American Society of Mechanical Engineers (ASME), 2007)Developing turbulent forced convection flow in a two-dimensional duct is simulated for Reynolds numbers ranging from 4560 to 12,000. Simultaneously developing velocity and temperature distributions ... -
Performance Evaluation of a Compartmented Cooling Coil Using the Monte Carlo Simulation Approach
(The American Society of Mechanical Engineers (ASME), 2007)A compartmented cooling coil is a single undivided coil section located in an intermediate point between the upstream and downstream sections of the air handling unit. A thermally insulated ... -
Characteristics of the Hydrodynamic Coefficient for Flow of a Steam-Water Mixture in a Pebble Bed
(The American Society of Mechanical Engineers (ASME), 2007)Pressure loss for flow of a steam-water mixture in a pebble bed is experimentally investigated (the first stage of the study was described in , , 2003 [High Temp., 41, pp. 371–383]). The ... -
An Experimental Study of the Friction Factor and Mass Transfer Performance of an Offset-Strip Fin Array at Very High Reynolds Numbers
(The American Society of Mechanical Engineers (ASME), 2007)Thermal-hydraulic performance data for offset-strip fin arrays are readily available in the range Re<10,000. However, in emerging applications in automotive and aerospace systems, where fan power ... -
Expansion Ratio Effects on Three-Dimensional Separated Flow and Heat Transfer Around Backward-Facing Steps
(The American Society of Mechanical Engineers (ASME), 2007)Direct numerical simulation methodology clarified the three-dimensional separated flow and heat transfer around three backward-facing steps in a rectangular channel, especially effects of channel ... -
Stochastic Heat Transfer in Fins and Transient Cooling Using Polynomial Chaos and Wick Products
(The American Society of Mechanical Engineers (ASME), 2007)Stochastic heat transfer problems are often solved using a perturbation approach that yields estimates of mean values and standard deviations for properties and boundary conditions that are random ... -
A Numerical Study of Flow and Heat Transfer Enhancement Using an Array of Delta-Winglet Vortex Generators in a Fin-and-Tube Heat Exchanger
(The American Society of Mechanical Engineers (ASME), 2007)This work is aimed at assessing the potential of winglet-type vortex generator (VG) “arrays” for multirow inline-tube heat exchangers with an emphasis on providing fundamental understanding of ... -
Anisotropic Heat Conduction Effects in Proton-Exchange Membrane Fuel Cells
(The American Society of Mechanical Engineers (ASME), 2007)The focus of this work is to study the effects of anisotropic thermal conductivity and thermal contact conductance on the overall temperature distribution inside a fuel cell. The gas-diffusion ... -
Discussion: “Second Law Analysis of Laminar Viscous Flow Through a Duct Subjected to Constant Wall Temperature” (Sahin, A. Z., 1998, ASME J. Heat Transfer, 120 , pp. 76–83)
(The American Society of Mechanical Engineers (ASME), 2007)In the paper , 1998, “ Second Law Analysis of Laminar Viscous Flow Through a Duct Subjected to Constant Wall Temperature” ASME J. Heat Transfer, 120(1), pp. 76–83, there are many errors in ... -
Closure to “Discussion of ‘Second Law Analysis of Laminar Viscous Flow Through a Duct Subjected to Constant Wall Temperature’ ” (2007, ASME J. Heat Transfer, 129 , p. 1302)
(The American Society of Mechanical Engineers (ASME), 2007)I would like to thank M. M. Awad for the time he spent and appreciate his consideration in reading and carefully reviewing the paper, Sahin, A. Z., 1998, “Second Law Analysis of Laminar ... -
Erratum: “Natural Convection in a Partitioned Vertical Enclosure With a Uniform Heat Flux” [Journal of Heat Transfer, 2007, 129(6), contents on inside cover]
(The American Society of Mechanical Engineers (ASME), 2007)The paper entitled “Natural Convection in a Partitioned Vertical Enclosure Heated With a Uniform Heat Flux” should be placed under the category “Natural and Mixed Convection.” It was put in ...