Journal of Heat Transfer: Recent submissions
Now showing items 3361-3380 of 3611
-
Practical Considerations for Waveguide-Ballistic Thermal Energy Conversion
(The American Society of Mechanical Engineers (ASME), 2008)The potential of converting heat energy into electrical energy using a previously reported waveguide-ballistic device is presented. The interactions between incident electromagnetic waves and free ... -
Intermediate Scaling of Turbulent Momentum and Heat Transfer in a Transitional Rough Channel
(The American Society of Mechanical Engineers (ASME), 2008)The properties of the mean momentum and thermal balance in fully developed turbulent channel flow on transitional rough surface have been explored by method of matched asymptotic expansions. ... -
Modeling the Thermal Conductivity and Phonon Transport in Nanoparticle Composites Using Monte Carlo Simulation
(The American Society of Mechanical Engineers (ASME), 2008)This paper presents a Monte Carlo simulation scheme to study the phonon transport and the thermal conductivity of nanocomposites. Special attention has been paid to the implementation of periodic ... -
Effect of Brownian Motion on Thermal Conductivity of Nanofluids
(The American Society of Mechanical Engineers (ASME), 2008)Nanofluids, i.e., liquids containing nanometer sized metallic or nonmetallic solid particles, show an increase in thermal conductivity compared to that of the pure liquid. In this paper, a simple ... -
Transient and Steady-State Experimental Comparison Study of Effective Thermal Conductivity of Al2O3∕Water Nanofluids
(The American Society of Mechanical Engineers (ASME), 2008)Nanofluids are being studied for their potential to enhance heat transfer, which could have a significant impact on energy generation and storage systems. However, only limited experimental data ... -
Alumina Nanoparticles Enhance the Flow Boiling Critical Heat Flux of Water at Low Pressure
(The American Society of Mechanical Engineers (ASME), 2008)Many studies have shown that addition of nanosized particles to water enhances the critical heat flux (CHF) in pool boiling. The resulting colloidal dispersions are known in the literature as ... -
A Photoelectrochemical Model of Proton Exchange Water Electrolysis for Hydrogen Production
(The American Society of Mechanical Engineers (ASME), 2008)A photoelectrochemical model for hydrogen production from water electrolysis using proton exchange membrane is proposed based on Butler-Volmer kinetics for electrodes and transport resistance in ... -
A Generic Approach to Coat Carbon Nanotubes With Nanoparticles for Potential Energy Applications
(The American Society of Mechanical Engineers (ASME), 2008)A generic and material-independent dry route based on electrostatic force directed assembly (ESFDA) is used to assemble various nanoparticles onto multiwalled carbon nanotubes (CNTs). Charged and ... -
Thermal Conductivity Equations Based on Brownian Motion in Suspensions of Nanoparticles (Nanofluids)
(The American Society of Mechanical Engineers (ASME), 2008)Thermal conductivity equations for the suspension of nanoparticles (nanofluids) have been derived from the kinetic theory of particles under relaxation time approximations. These equations, which ... -
Combined Effect of Temperature Modulation and Magnetic Field on the Onset of Convection in an Electrically Conducting-Fluid-Saturated Porous Medium
(The American Society of Mechanical Engineers (ASME), 2008)The effect of temperature modulation on the onset of thermal convection in an electrically conducting fluid-saturated-porous medium, heated from below, has been studied using linear stability ... -
Natural Convection Heat Transfer in a Partially Open Square Cavity With a Thin Fin Attached to the Hot Wall
(The American Society of Mechanical Engineers (ASME), 2008)A computational study of steady, laminar, natural convective fluid flow in a partially open square enclosure with a highly conductive thin fin of arbitrary length attached to the hot wall at ... -
Carbon Nanotubes, Synthesis, Growth and Orientation Control in Opposed Flow Diffusion Flames
(The American Society of Mechanical Engineers (ASME), 2008)The combustion synthesis of carbon nanotubes is reviewed, examining their formation and control in diffusion flames. Much of the initial work in this area employed coflow diffusion flames and ... -
The Experimental Exploration of Embedding Phase Change Materials With Graphite Nanofibers for the Thermal Management of Electronics
(The American Society of Mechanical Engineers (ASME), 2008)To improve the thermal performance of phase change materials (PCMs), graphite nanofibers were embedded into a paraffin PCM. The thermal effects of graphite fiber loading levels (0–5wt%) and ... -
Transient Critical Heat Fluxes of Subcooled Water Flow Boiling in a Short Vertical Tube Caused by Exponentially Increasing Heat Inputs
(The American Society of Mechanical Engineers (ASME), 2008)The transient critical heat fluxes (CHFs) of the subcooled water flow boiling for the flow velocities (u=4.0–13.3m∕s), the inlet subcoolings (ΔTsub,in=68.08–161.12K), the inlet pressures ... -
Effect of Rarefaction, Dissipation, and Accommodation Coefficients on Heat Transfer in Microcylindrical Couette Flow
(The American Society of Mechanical Engineers (ASME), 2008)This paper examines the effects of rarefaction, dissipation, curvature, and accommodation coefficients on flow and heat transfer characteristics in rotating microdevices. The problem is modeled as ... -
Similarity Solution of Unaxisymmetric Heat Transfer in Stagnation-Point Flow on a Cylinder With Simultaneous Axial and Rotational Movements
(The American Society of Mechanical Engineers (ASME), 2008)Similarity solution of unaxisymmetric heat transfer of an unsteady viscous flow in the vicinity of an axisymmetric stagnation point of an infinite circular cylinder with simultaneous axial and ... -
Temperature/Heat Analysis of Annular Fins of Hyperbolic Profile Relying on the Simple Theory for Straight Fins of Uniform Profile
(The American Society of Mechanical Engineers (ASME), 2008)This technical brief addresses an elementary analytic procedure for solving approximately the quasi-1D heat conduction equation (a generalized Airy equation) governing the annular fin of hyperbolic ... -
Boiling Heat Transfer Rates for Small Precisely Placed Water Droplets on a Heated Horizontal Plate
(The American Society of Mechanical Engineers (ASME), 2008)Two small horizontal surfaces, heated to temperatures up to 220°C, were cooled by small (50–300 mm diameter) room-temperature droplets at 1 atmosphere pressure. One surface was a 10×10 ... -
Latent Heat Fluxes Through Soft Materials With Microtruss Architectures
(The American Society of Mechanical Engineers (ASME), 2008)Microscale truss architectures provide high mechanical strength, light weight, and open porosity in polymer sheets. Liquid evaporation and transport of the resulting vapor through truss voids cool ... -
Special Issue on Energy Nanotechnology
(The American Society of Mechanical Engineers (ASME), 2008)It is with great pleasure that we present this special issue of the Journal of Heat Transfer, dedicated to Energy Nanotechnology. This focus area is the natural convergence of two subjects ...