Journal of Heat Transfer: Recent submissions
Now showing items 3301-3320 of 3611
-
High-Resolution Measurements at Nucleate Boiling of Pure FC-84 and FC-3284 and Its Binary Mixtures
(The American Society of Mechanical Engineers (ASME), 2009)In a special boiling cell, vapor bubbles are generated at single nucleation sites on top of a 20μm thick stainless steel heating foil. An infrared camera captures the rear side of the heating ... -
Rapid Boiling of a Two-Phase Droplet in an Immiscible Liquid at High Superheat
(The American Society of Mechanical Engineers (ASME), 2009)This work studies experimentally the rapid boiling of a droplet rising in a host liquid environment, within a range of superheats (0.2<Ja∗<0.5) not previously investigated. The direct-contact ... -
Effect of Internal Wick Structure on Liquid-Vapor Oscillatory Flow and Heat Transfer in an Oscillating Heat Pipe
(The American Society of Mechanical Engineers (ASME), 2009)Liquid-vapor oscillating flow and heat transfer in a vertically placed oscillating heat pipe (OHP) with a sintered particle wick structure are analyzed in this paper. The oscillatory flow of ... -
Flow Boiling of Coolant (HFE-7000) Inside Structured and Plain Wall Microchannels
(The American Society of Mechanical Engineers (ASME), 2009)Flow boiling was experimentally studied using coolant HFE-7000 for two types of parallel microchannels: a plain-wall microchannel and a microchannel with structured reentrant cavities on the side ... -
Recent Research in Molecular-to-Large-Scale Heat Transfer With Multiphase Interfaces and Their Applications
(The American Society of Mechanical Engineers (ASME), 2009)Heat and mass transfer across multiphase interfaces, or liquid-vapor/gas-solid phase boundaries, represent the most fundamental transport phenomena in diverse applications, which include boiling, ... -
Molecular-to-Large-Scale Heat Transfer With Multiphase Interfaces: Current Status and New Directions
(The American Society of Mechanical Engineers (ASME), 2009)The scientific understanding of multiphase interfaces and the associated convective mass, momentum, and heat transport across and along their boundaries, provide the fundamental underpinnings of ... -
Flow Boiling Heat Transfer in Horizontal Metal-Foam Tubes
(The American Society of Mechanical Engineers (ASME), 2009)The two-phase flow and boiling heat transfer in horizontal metal-foam filled tubes are experimentally investigated. The results show that the heat transfer is almost doubled by reducing the cell ... -
Enhancement of Heat Transfer Behind Sliding Bubbles
(The American Society of Mechanical Engineers (ASME), 2009)The time-dependent temperature distribution on an inclined, thin-foil uniform-heat-generation heater was used to infer the heat transfer enhancement caused by the passage of an FC-87 bubble sliding ... -
Experimental and Numerical Study of Single Bubble Dynamics on a Hydrophobic Surface
(The American Society of Mechanical Engineers (ASME), 2009)The growth and departure of single bubbles on two smooth surfaces with very different wettabilities are studied using high-speed video microscopy and numerical simulations. Isolated artificial ... -
Bubble-Induced Water Hammer and Cavitation in Microchannel Flow Boiling
(The American Society of Mechanical Engineers (ASME), 2009)While microchannel flow boiling has received much research attention, past work has not considered the impact of acoustic waves generated by rapidly nucleating bubbles. The present work provides ... -
Correlation for Flow Boiling Critical Heat Flux in Thin Rectangular Channels
(The American Society of Mechanical Engineers (ASME), 2009)The effect of heated length on critical heat flux (CHF) in thin rectangular channels under atmospheric pressure has been studied. CHF in small channels has been widely studied in the last ... -
Heat Transfer Photogallery
(The American Society of Mechanical Engineers (ASME), 2008)The Twelfth Heat Transfer Photogallery was sponsored by the K-22 Heat Transfer Visualization Committee for the 2007 International Mechanical Engineering Congress and Exhibition (IMECE) held in ... -
Discussion of Boundary Conditions of Transpiration Cooling Problems Using Analytical Solution of LTNE Model
(The American Society of Mechanical Engineers (ASME), 2008)To compare five kinds of different boundary conditions (BCs), an analytical solution of a steady and one-dimensional problem of transpiration cooling described by a local thermal nonequilibrium ... -
A Light Transmission Based Liquid Crystal Thermography System
(The American Society of Mechanical Engineers (ASME), 2008)This paper presents results from a study aimed at developing a novel thermochromic liquid crystal (TLC) temperature measurement system that uses light transmission instead of light reflection to ... -
Impact of Interface Resistance on Pulsed Thermoelectric Cooling
(The American Society of Mechanical Engineers (ASME), 2008)Pulsed thermoelectric cooling is an attractive approach for the site specific thermal management of infrared sensors and other low-heat flux devices. Intense Joule heating caused by electrical ... -
Numerical Investigation of Thermofluid Flow Characteristics With Phase Change Against High Heat Flux in Porous Media
(The American Society of Mechanical Engineers (ASME), 2008)This study numerically evaluates thermofluid flow characteristics in porous medium by a newly developed “modified two-phase mixture model” applying Ergun’s law and a two-energy model instead of ... -
The Critical Heat Flux Condition With Water in a Uniformly Heated Microtube
(The American Society of Mechanical Engineers (ASME), 2008)The critical heat flux (CHF) condition needs to be well understood for designing miniature devices involving two-phase flow. Experiments were performed to determine the CHF condition for a single ... -
Numerical Analysis of Wooden Porous Media Effects on Heat Transfer From a Staggered Tube Bundle
(The American Society of Mechanical Engineers (ASME), 2008)A numerical analysis of forced convective heat transfer from a staggered tube bundle with various low conductivity wooden porous media inserts at maximum Reynolds numbers 100 and 300, Prandtl ... -
Heat Transfer From a Rotating Disk to Fluids for a Wide Range of Prandtl Numbers Using the Asymptotic Model
(The American Society of Mechanical Engineers (ASME), 2008)A simple method for calculating heat transfer from a rotating disk to fluids for a wide range of Prandtl numbers using asymptotic analysis is presented. Nusselt numbers for a heated rotating ... -
Heatline Visualization of Natural Convection in a Porous Cavity Occupied by a Fluid With Temperature-Dependent Viscosity
(The American Society of Mechanical Engineers (ASME), 2008)Temperature-dependent viscosity effect in buoyancy driven flow of a gas or a liquid in an enclosure filled with a porous medium is studied numerically based on the general model of momentum ...