Journal of Heat Transfer: Recent submissions
Now showing items 2961-2980 of 3611
-
Effect of Pin Density on Heat-Mass Transfer and Fluid Flow at Low Reynolds Numbers in Minichannels
(The American Society of Mechanical Engineers (ASME), 2010)Previous investigations on the performance of straight pins, pins with tip clearance, and profiled fins showed that closely packed cylindrical pin fins are very competitive with the modified ... -
Effect of Return Bend and Entrance on Heat Transfer in Thermally Developing Laminar Flow in Round Pipes of Some Heat Transfer Fluids With High Prandtl Numbers
(The American Society of Mechanical Engineers (ASME), 2010)The paper presents experimental results and analysis of heat transfer in a thermally developing region of round pipes for three fluids typically used as low temperature coolants, in the range ... -
Determination of Time-Delay Parameters in the Dual-Phase Lagging Heat Conduction Model
(The American Society of Mechanical Engineers (ASME), 2010)The study of thermal transport based on the dual-phase lagging model involves not only the well known thermal properties but also two additional time parameters. Those parameters permit to take ... -
Heat Transport Capability and Fluid Flow Neutron Radiography of Three-Dimensional Oscillating Heat Pipes
(The American Society of Mechanical Engineers (ASME), 2010)An experimental investigation into the parameters affecting heat transport in two three-dimensional oscillating heat pipes (OHPs) was implemented. A three-dimensional OHP is one in which the center ... -
On the Mechanism of Pool Boiling Critical Heat Flux Enhancement in Nanofluids
(The American Society of Mechanical Engineers (ASME), 2010)The pool boiling characteristics of water-based nanofluids with alumina and titania nanoparticles of 0.01 vol % were investigated on a thermally heated disk heater at saturated temperature and ... -
Heat and Mass Transfer on the Unsteady Magnetohydrodynamic Flow Due to a Porous Rotating Disk Subject to a Uniform Outer Radial Flow
(The American Society of Mechanical Engineers (ASME), 2010)An unsteady flow and heat transfer of an incompressible electrically conducting fluid over a porous rotating infinite disk impulsively set into motion are studied in the present paper. The disk ... -
Network Modeling of Fin-and-Tube Evaporator Performance Under Dry and Wet Conditions
(The American Society of Mechanical Engineers (ASME), 2010)A new neural network modeling approach to the evaporator performance under dry and wet conditions has been developed. Not only the total cooling capacity but also the sensible heat ratio and ... -
New Bio-Inspired, Multiphase Forced Convection Cooling by ABS Plastic or Encapsulated Paraffin Beads
(The American Society of Mechanical Engineers (ASME), 2010)Preliminary experimental results of forced convection by octadecane paraffin (encapsulating phase-change material (EPCM)) particles, acrylonitrile butadiene styrene plastic particles, or by clear (of ... -
Direct Numerical Simulation of Near Field Thermal Radiation Based on Wiener Chaos Expansion of Thermal Fluctuating Current
(The American Society of Mechanical Engineers (ASME), 2010)A methodology is proposed, which is capable of determining the near field thermal radiation based on the Wiener chaos expansion. The approach has no explicit constraints on the geometry and ... -
The Onset of Convection in a Layer of Cellular Porous Material: Effect of Temperature-Dependent Conductivity Arising From Radiative Transfer
(The American Society of Mechanical Engineers (ASME), 2010)The onset of convection in a horizontal layer of a cellular porous material heated from below is investigated. The problem is formulated as a combined conductive-convective-radiative problem in ... -
Theory of Fractional Order Generalized Thermoelasticity
(The American Society of Mechanical Engineers (ASME), 2010)In this work, a new model of thermoelasticity theory has been constructed in the context of a new consideration of heat conduction with fractional order, and its uniqueness theorem has been ... -
Tomography-Based Analysis of Radiative Transfer in Reacting Packed Beds Undergoing a Solid-Gas Thermochemical Transformation
(The American Society of Mechanical Engineers (ASME), 2010)A reacting packed-bed undergoing a high-temperature thermochemical solid-gas transformation is considered. The steam- and dry-gasification of carbonaceous materials to syngas is selected as the model ... -
Simultaneous Measurement of Three-Dimensional Soot Temperature and Volume Fraction Fields in Axisymmetric or Asymmetric Small Unconfined Flames With CCD Cameras
(The American Society of Mechanical Engineers (ASME), 2010)A nonintrusive measurement technique is presented numerically for simultaneous measurement of three-dimensional (3D) soot temperature and volume fraction fields in the axisymmetric or asymmetric ... -
Numerical Studies on Microwave Heating of Thermoplastic-Ceramic Composites Supported on Ceramic Plates
(The American Society of Mechanical Engineers (ASME), 2010)A detailed theoretical analysis has been carried out to study efficient microwave assisted heating of thermoplastic (Nylon 66) slabs via polymer-ceramic-polymer composite attached with ceramic plate ... -
Numerical Determination of Radiative View Factors Using Ray Tracing
(The American Society of Mechanical Engineers (ASME), 2010)A ray-tracing method is presented for numerically determining radiative view factors in complex three-dimensional geometries. This method uses a set of “primitive” shapes to approximate the required ... -
Reduced Models for Radiative Heat Transfer Analysis Through Anisotropic Fibrous Medium
(The American Society of Mechanical Engineers (ASME), 2010)Reduced models for radiative heat transfer analysis through anisotropic medium are presented and evaluated. The models include two equivalent heat transfer models through isotropic medium using ... -
Thermal Wave Based on the Thermomass Model
(The American Society of Mechanical Engineers (ASME), 2010)In times comparable to the characteristic time of the energy carriers, Fourier’s law of heat conduction breaks down and heat may propagate as waves. Based on the concept of thermomass, which ... -
Raman Thermometry Measurements and Thermal Simulations for MEMS Bridges at Pressures From 0.05 Torr to 625 Torr
(The American Society of Mechanical Engineers (ASME), 2010)This paper reports on experimental and computational investigations into the thermal performance of microelectromechanical systems (MEMS) as a function of the pressure of the surrounding gas. High ... -
Air-Side Heat-Transfer Enhancement by a New Winglet-Type Vortex Generator Array in a Plain-Fin Round-Tube Heat Exchanger
(The American Society of Mechanical Engineers (ASME), 2010)The impact of a vortex-generation technique for air-side heat-transfer improvement is experimentally investigated through full-scale wind-tunnel testing of a plain-fin round-tube heat exchanger under ... -
High Rotation Number Effect on Heat Transfer in a Triangular Channel With 45 deg, Inverted 45 deg, and 90 deg Ribs
(The American Society of Mechanical Engineers (ASME), 2010)Heat transfer and pressure drop have been experimentally investigated in an equilateral triangular channel (Dh=1.83 cm), which can be used to simulate the internal cooling passage near the leading ...