Journal of Structural Engineering: Recent submissions
Now showing items 4741-4760 of 10765
-
Structural Fire Safety of Circular Concrete Railroad Tunnel Linings
(American Society of Civil Engineers, 2009)In many tunnel designs, lining cross section is selected based on construction requirements rather than design loads. A constant cross section is typically used along a tunnel especially for tunnels constructed by tunnel ... -
Reversed Cyclic Performance of Shear Walls with Wood Panels Attached to Cold-Formed Steel with Pins
(American Society of Civil Engineers, 2009)Screws are the only fasteners approved in the 2006 International Building Code for attaching wood structural sheathing to cold-formed steel framing for shear walls. Steel pins also provide an effective and efficient means ... -
The Next Step for AF&PA/ASCE 16-95: Performance-Based Design of Wood Structures
(American Society of Civil Engineers, 2009) -
Statistical Analysis of Vibration Modes of a Suspension Bridge Using Spatially Dense Wireless Sensor Network
(American Society of Civil Engineers, 2009)A spatially dense wireless sensor network was designed, developed and installed on a long-span suspension bridge for a -
Low-Frequency Variations of Force Coefficients on Square Cylinders with Sharp and Rounded Corners
(American Society of Civil Engineers, 2009)Square lighting poles with sharp or round corners have been observed to exhibit large amplitude oscillations with a frequency that is near that of their first mode. This frequency is one order of magnitude lower than that ... -
Stiffness Optimization for Wind-Induced Dynamic Serviceability Design of Tall Buildings
(American Society of Civil Engineers, 2009)Contemporary tall buildings with increasing height and slenderness are highly sensitive to the actions of wind. The structural design of modern tall buildings is generally governed by the need to provide adequate strength ... -
Impact Response of Reinforced Concrete Beam and Its Analytical Evaluation
(American Society of Civil Engineers, 2009)This paper examines the impact responses of reinforced concrete (RC) beams through an experimental study and presents an analytical model developed to predict the maximum midspan deflection and maximum impact load, which ... -
Performance of Log Shear Walls Subjected to Monotonic and Reverse-Cyclic Loading
(American Society of Civil Engineers, 2010)Low-rise buildings are typically designed with shear walls and horizontal diaphragms to resist lateral load during windstorms and earthquakes. Although seismic performance and lateral load resistance behavior are generally ... -
Experimental and Numerical Investigations on the Seismic Behavior of Lightly Reinforced Concrete Beam-Column Joints
(American Society of Civil Engineers, 2009)The experimental and analytical investigations carried out on lightly reinforced concrete beam-column joints subjected to seismic loading are presented in this paper. Five 3/4-scale reinforced concrete beam-column joints ... -
Static Design Recommendations for Slotted End HSS Connections in Tension
(American Society of Civil Engineers, 2009)The design of slotted end hollow structural section connections in tension, according to the philosophy behind contemporary specifications [ANSI/AISC 360-05, CAN/CSA-S16-01, and EN 1993-1-8; 2005 (E)], requires checking ... -
Development of Nailed Wood Joint Element in ABAQUS
(American Society of Civil Engineers, 2009)Testing showed that the hysteretic behavior of nailed wood joints governs the response of many wood systems when subjected to lateral loadings. Unfortunately, commercially available software does not have the appropriate ... -
Integrated Design of Controlled Linear Structural Systems
(American Society of Civil Engineers, 2009)This paper addresses the integrated design of civil engineering structures with control systems. Simultaneous optimization of such controlled structures is considered, showing that new alternative solutions can be achieved ... -
Development of a Wood-Frame Shear Wall Model in ABAQUS
(American Society of Civil Engineers, 2009)After modifications, the Bouc-Wen-Barber-Wen (BWBN) model was used in simulating the hysteretic behavior of wood light-frame shear walls. A complete shear wall model is composed of boundary framing members and two-diagonal ... -
Backbone Model for Confined Masonry Walls for Performance-Based Seismic Design
(American Society of Civil Engineers, 2009)In this study, a performance-based model is proposed, capable of simulating seismic behavior of typical confined masonry (CM) walls whose response is governed by shear deformations. This model is developed on the basis of ... -
Wood I-Joists with Excessive Web Openings: An Experimental and Analytical Investigation
(American Society of Civil Engineers, 2009)Two series of tests with different depth wood I-joists were conducted to study the effects of circular and square web openings and the placement of steel angle retrofits at openings. Finite-element analysis of all test ... -
Bridge System Performance Assessment from Structural Health Monitoring: A Case Study
(American Society of Civil Engineers, 2009)Based on the long-term monitored strain data induced by heavy vehicle traffic on an existing bridge, this paper presents an efficient approach to assessing the bridge system performance through a series-parallel system ... -
Tests and Design of Aluminum Tubular Sections Subjected to Concentrated Bearing Load
(American Society of Civil Engineers, 2009)This paper presents a series of tests on high strength aluminum square hollow sections subjected to concentrated bearing load. A total of 64 web-bearing tests was conducted. The test specimens were fabricated by extrusion ... -
Experimental Study of a Self-Centering Beam–Column Connection with Bottom Flange Friction Device
(American Society of Civil Engineers, 2009)A new beam-to-column connection for earthquake-resistant moment-resisting frames is introduced. The connection has a beam bottom flange friction device (BFFD) and posttensioned (PT) high-strength steel strands running ... -
Seismic Reliability Analysis of Diagonal-Braced and Structural-Panel-Sheathed Wood Shear Walls
(American Society of Civil Engineers, 2009)Reliability-based assessment of seismic performance of wood shear walls needs to consider many uncertainties arising from earthquake ground motions, material properties, carried mass, and analytical models. Using a response ... -
Strategic Network Utilization in a Wireless Structural Control System for Seismically Excited Structures
(American Society of Civil Engineers, 2009)The benefits associated with structural control include the mitigation of undesired structural responses and reduction in the probability of damage to structural components during seismic events. Structural control systems ...