Journal of Structural Engineering: Recent submissions
Now showing items 4701-4720 of 10765
-
Spectral Ground Motion Intensity Based on Capacity and Period Elongation
(American Society of Civil Engineers, 2011)Ground motion intensity parameters are used to express the relationship between expected structural damage and the seismic forces imposed. The graphical representation of damage probability as a function of ground motion ... -
Experimental Study of Damage Detection by Data-Driven Subspace Identification and Finite-Element Model Updating
(American Society of Civil Engineers, 2009)The need to identify the physical properties of a structure given its force-response (input-output) relationship is driven primarily by the need to validate the approximate solution models, such as finite-element models. ... -
Editor’s Note
(American Society of Civil Engineers, 2009) -
Ultimate State of Thin-Walled Circular Steel Columns under Bidirectional Seismic Accelerations
(American Society of Civil Engineers, 2009)The effects of coupling of two horizontal seismic acceleration components are investigated for the ultimate states of thin-walled circular steel columns used as bridge piers. Ultimate states of these columns are mainly ... -
Cyclic Testing of a Buckling Restrained Braced Frame with Unconstrained Gusset Connections
(American Society of Civil Engineers, 2009)Buckling restrained braces are intended to yield in both axial tension and compression. The gusset plates connecting them to the adjacent beams and columns are thick and often stiffened to prevent buckling, and as a result ... -
Laboratory Tests and Numerical Analyses of Prefabricated Timber-Concrete Composite Floors
(American Society of Civil Engineers, 2010)This paper describes tests on a novel composite floor system constructed by connecting prefabricated concrete slabs to timber joists. Seven types of shear connectors have been developed and tested: lag screws, either alone ... -
Editor’s Note
(American Society of Civil Engineers, 2009) -
Horizontal Wind Loads on Open-Frame, Low-Rise Buildings
(American Society of Civil Engineers, 2010)Wind tunnel tests of open-frame, low-rise buildings were carried out to determine the drag (base shear) and bracing loads in the direction normal to the frames (parallel to the ridge). In total, 18 configurations were ... -
Discussion of “Estimating Fundamental Frequencies of Tall Buildings” by Clive L. Dym and Harry E. Williams
(American Society of Civil Engineers, 2009) -
Local Buckling of RBS Beams Subjected to Cyclic Loading
(American Society of Civil Engineers, 2009)This paper presents an analytical study of local instability behavior in a reduced beam section (RBS) beam subjected to cyclic loading. A general finite-element method is used for numerical experiments here. Even though ... -
Damage-Based Design Earthquake Loads for Single-Degree-Of-Freedom Inelastic Structures
(American Society of Civil Engineers, 2011)This paper develops a new framework for modeling design earthquake loads for inelastic structures. Limited information on strong ground motions is assumed to be available only at the given site. The design earthquake ... -
Design of Steel Plate Shear Walls Considering Boundary Frame Moment Resisting Action
(American Society of Civil Engineers, 2009)Conventional design of steel plate shear walls (SPSWs) assumes that 100% of the story shear is resisted by each infill panel. Following this approach, strength provided by the boundary frame moment resisting action, which ... -
In-Plane Load-Deflection Behavior and Buckling of Pressurized Fabric Arches
(American Society of Civil Engineers, 2009)This study focuses on the in-plane load-deflection and buckling response of pressurized fabric arches of constant circular cross section. These lightweight portable structural members support tents used for temporary medical ... -
Effects of Heating on the Behavior of Lead-Rubber Bearings. I: Theory
(American Society of Civil Engineers, 2009)The energy dissipated per cycle and the characteristic strength of lead-rubber bearings reduce with increasing number of cycles as a result of heating of the lead core. The reduction is substantial depending on the geometric ... -
Study on the Effect of Uplift-Restraint on the Seismic Response of Base-Isolated Structures
(American Society of Civil Engineers, 2009)Under certain conditions isolation bearings can sustain undesirable tensile forces or uplift, the occurrence of which potentially entail detrimental effects on the isolation-system and the superstructure. This study reports ... -
Deformation Analysis of Prestressed Continuous Steel-Concrete Composite Beams
(American Society of Civil Engineers, 2009)Deformation calculation of prestressed continuous steel-concrete composite beams accounting for the slip effect between the steel and concrete interface under service loads is analyzed. A simplified analytical model is ... -
Effects of Heating on the Behavior of Lead-Rubber Bearings. II: Verification of Theory
(American Society of Civil Engineers, 2009)The energy dissipated per cycle and the characteristic strength of lead-rubber bearings reduce with increasing number of cycles as a result of heating of the lead core. A theory which is capable of predicting the histories ... -
Analysis of Steel Plate Shear Walls Using the Modified Strip Model
(American Society of Civil Engineers, 2009)Unstiffened steel plate shear walls are an effective and economical method of resisting lateral forces on structures due to wind and earthquakes. Structural engineers require the ability to assess the inelastic structural ... -
Efficient Beam-Column Element with Variable Inelastic End Zones
(American Society of Civil Engineers, 2009)The paper presents a new beam-column element that combines computational efficiency with accuracy. The element uses only one monitoring section in each end inelastic zone of the structural member, but accounts for the ... -
Reexamination of the Vibrational Period of Coupled Shear Walls by Differential Transformation
(American Society of Civil Engineers, 2009)In multistory buildings, coupled shear walls are frequently used as the main lateral load resisting system, the seismic design of which requires some knowledge of their periods of vibration. Although the vibrational ...