Journal of Structural Engineering: Recent submissions
Now showing items 4361-4380 of 10765
-
Postearthquake Fire Performance of Sprayed Fire-Resistive Material on Steel Moment Frames
(American Society of Civil Engineers, 2011)This paper describes damage patterns in sprayed fire resistive material (SFRM) on steel moment frame beam-column assemblages owing to a strong seismic event, and the thermal consequences of this damage when exposed to ... -
Failure Assessment of Lightly Reinforced Floor Slabs. II: Analytical Studies
(American Society of Civil Engineers, 2011)This paper describes numerical and analytical assessments of the ultimate response of floor slabs. Simplified analytical models and finite-element simulations are described and validated against the experimental results ... -
Flexural Behavior of Steel Fibrous Reinforced Concrete Deep Beams
(American Society of Civil Engineers, 2012)Experimental research was carried out regarding the flexural behavior of deep beams cast with plain and fibrous concrete with hooked steel fibers, and subjected to monotonic vertical loads. Four deep fiber-reinforced ... -
Experimental Performance of Concrete Columns with Composite Jackets under Blast Loading
(American Society of Civil Engineers, 2012)Measures to prevent progressive collapse of structures include protection of critical elements such as columns. In support of this goal, nine tests were conducted to assess the as-built performance of typical columns and ... -
Performance and Characterization of Shear Ties for Use in Insulated Precast Concrete Sandwich Wall Panels
(American Society of Civil Engineers, 2012)Insulated precast concrete sandwich wall panels are commonly used for exterior cladding on building structures. The insulation is sandwiched between exterior and interior concrete layers to reduce the heating and cooling ... -
DoD Research and Criteria for the Design of Buildings to Resist Progressive Collapse
(American Society of Civil Engineers, 2011)The collapse of conventional/nonhardened structures was a concern of the U.S. Department of Defense (DoD) for years before the collapse of the World Trade Center (WTC) towers during the terrorist attacks on September 11, ... -
Reliability Acceptance Criteria for Deteriorating Elements of Structural Systems
(American Society of Civil Engineers, 2011)A systematic approach to determining reliability-based acceptance criteria for deteriorating elements in structural systems is proposed as a basis for calibration of safety factors in codes and standards and for verifying ... -
Numerical Investigation into Headed Shear Connectors under Fire
(American Society of Civil Engineers, 2012)Three-dimensional thermal and mechanical coupled finite-element models are proposed to study the structural behaviors of shear connectors under fire. Thermal, mechanical, and geometrical nonlinearities are incorporated ... -
Effect of Spandrel Beam to Double Tee Connection Characteristic on Flexure-Controlled Precast Diaphragms
(American Society of Civil Engineers, 2012)Precast spandrel beams are often used on the perimeter of precast buildings to support the precast floor units. These elements are typically not considered part of the lateral force resisting system. However, the presence ... -
Earthquake Analysis of Arch Dams: Factors to Be Considered
(American Society of Civil Engineers, 2012)The factors that significantly influence the three-dimensional analysis of arch dams are identified: the semiunbounded size of the reservoir and foundation-rock domains, dam-water interaction, wave absorption at the reservoir ... -
Seismic Performance of Low-to-Moderate Height Eccentrically Braced Steel Frames Designed for North American Seismic Conditions
(American Society of Civil Engineers, 2012)The global seismic response of 3- and 8-story eccentrically braced frames (EBFs), designed for western and eastern North American locations, is studied using nonlinear time history analysis. Analytical models were built ... -
Performance Examination of Two Seismic Strengthening Procedures by Pseudodynamic Testing
(American Society of Civil Engineers, 2012)Pseudodynamic testing was employed to observe the seismic performance of two retrofit methods on two-story, three-bay frame structures. The test frames had hollow clay tile (HCT) infill in the central bay and incorporated ... -
Transverse versus Longitudinal Eigenperiods of Multispan Seismically Isolated Bridges
(American Society of Civil Engineers, 2012)This paper is motivated from the wider need in system identification studies to identify and interpret the eigenvalues of seismically isolated bridges from field measurements. The paper examines the transverse eigenvalues ... -
Behavior of Self-Centering Steel Plate Shear Walls and Design Considerations
(American Society of Civil Engineers, 2012)This paper presents insights on the combined contribution of posttensioning and beam-to-column joint rocking connection in self-centering steel plate shear walls (SC-SPSWs). Moment, shear, and axial force diagrams along ... -
Experimental Behavior and Mechanical Modeling of Dissipative T-Stub Connections
(American Society of Civil Engineers, 2012)This work aims to enhance the energy-dissipation capacity of classical rectangular T-stubs by proposing an hourglass shape for the T-stub flange according to the approach usually adopted for added damping and stiffness ... -
Elastic Stiffness Comparisons between RBS Beams with Either Flange or Web Reductions
(American Society of Civil Engineers, 2012)This paper compares the elastic stiffness of reduced beam section (RBS) beams with either flange or web reductions. The former has received considerable attention. However, recently the latter has been shown to have superior ... -
Influence of Steel Fibers and Headed Bars on the Serviceability of High-Strength Concrete Corbels
(American Society of Civil Engineers, 2012)Vertical loading tests are reported for six double-sided, high-strength concrete corbel specimens. The primary variables of the investigation were the percentage of steel fibers and the anchorage method of the main tension ... -
Redundancy and Robustness, or When Is Redundancy Redundant?
(American Society of Civil Engineers, 2011)The redundancy of a structure refers to the extent of degradation the structure can suffer without losing some specified elements of its functionality. However, because future structural degradation is unknown during design ... -
Sources of Confusion in the Determination of ASTM Repetitive Member Factors for the Allowable Properties of Wood Products
(American Society of Civil Engineers, 2012)Confusion in the literature about the definition and calculation of repetitive member factors is identified. This confusion casts some doubt on the validity of the 1.15 repetitive member factor permitted in ASTM standards ... -
Compressive Behavior of Longitudinally Cracked Timber Columns Retrofitted Using FRP Sheets
(American Society of Civil Engineers, 2012)This paper presents the results of a study on the compressive behavior of timber columns with longitudinal cracks. Material property tests and full-scale compression tests were conducted to investigate the failure modes ...