Journal of Structural Engineering: Recent submissions
Now showing items 4341-4360 of 10765
-
Seismic Performance of Semirigid Moment-Resisting Frames under Far and Near Field Records
(American Society of Civil Engineers, 2012)The seismic performance of low-rise frames with energy dissipative semirigid connections is evaluated under far and near field artificial ground motion records. Four different connection capacities are employed in the ... -
Influence of Model Parameter Uncertainty on Seismic Transverse Response and Vulnerability of Steel–Concrete Composite Bridges with Dual Load Path
(American Society of Civil Engineers, 2012)This paper uses a fully probabilistic approach to investigate the seismic response of multispan continuous bridges with dissipative piers and a steel–concrete composite (SCC) deck, the motion of which is transversally ... -
Shake-Table Studies of a Four-Span Bridge Model with Advanced Materials
(American Society of Civil Engineers, 2012)As part of a major study on the seismic response of bridge systems with conventional and advanced details, a large-scale model of a 4-span bridge incorporating several innovative plastic hinges was recently tested on shake ... -
Cost Optimum Design of Posttensioned I-Girder Bridge Using Global Optimization Algorithm
(American Society of Civil Engineers, 2012)This paper presents an optimization approach to the design of simply supported, post-tensioned, prestressed concrete I-girder bridges. The objective is to minimize the total cost of the structure, considering cost of ... -
Stability of Elastomeric and Lead-Rubber Seismic Isolation Bearings
(American Society of Civil Engineers, 2012)Elastomeric and lead-rubber bearings are two commonly used types of seismic isolation devices. During seismic events, some of the bearings in an isolation system will be subjected to large axial compressive loads, caused ... -
SHMS-Based Fatigue Reliability Analysis of Multiloading Suspension Bridges
(American Society of Civil Engineers, 2012)Long-span suspension bridges carrying both highway and railway have been built in wind-prone regions. The estimation of fatigue damage of such bridges under the long-term combined action of railway, highway, and wind loading ... -
Design of Retaining Walls Using Big Bang–Big Crunch Optimization
(American Society of Civil Engineers, 2012)A procedure is developed for designing low-cost or low-weight cantilever reinforced concrete retaining walls, with base shear keys, using big bang–big crunch (BB-BC) optimization. The objective of the optimization is to ... -
Fundamental Behavior of Steel Beam-Columns and Columns under Fire Loading: Experimental Evaluation
(American Society of Civil Engineers, 2011)This paper presents the results of experimental investigations conducted to determine the fundamental behavior of steel members under fire loading. A total of eleven full-scale steel members were tested under combined ... -
Drive-In Steel Storage Racks I: Stiffness Tests and 3D Load-Transfer Mechanisms
(American Society of Civil Engineers, 2012)Steel storage racks, made of cold-formed steel, are used extensively in industry for storing goods. Two main racking systems prevail, referred to as selective racks and drive-in racks. International racking design codes ... -
Evaluation of Force-Based Frame Element Response Sensitivity Formulations
(American Society of Civil Engineers, 2012)The direct differentiation method (DDM) has been shown to be an accurate and efficient approach to computing the sensitivity of structural response to uncertain parameters of constitutive models and finite-element formulations. ... -
Drive-In Steel Storage Racks. II: Reliability-Based Design for Forklift Truck Impact
(American Society of Civil Engineers, 2012)Steel drive-in racks are susceptible to structural failure from accidental impact by operating forklift trucks. Under impact, the upright bends and the supported pallets may drop through the rack to cause structural collapse ... -
Modeling Structural Degradation of RC Bridge Columns Subjected to Earthquakes and Their Fragility Estimates
(American Society of Civil Engineers, 2012)Current seismic design of bridges is based on “one-time” performance of the bridges during the design seismic event. However, there might be a considerable probability of observing more than one damaging earthquakes in a ... -
Experimental Evaluation of Thin Composite Floor Assemblies under Fire Loading
(American Society of Civil Engineers, 2011)This paper presents the behavior observations, results, and findings from experimental investigations of the structural behavior of thin composite floor systems subjected to combined gravity loads and fire loading. The -
Approximations in Progressive Collapse Modeling
(American Society of Civil Engineers, 2011)Assumptions must necessarily be made when the collapse response of structures is investigated using simulation models. The type and extent of modeling assumptions depend on the computational resources available, modeling ... -
Bearing Strength Capacity of Continuous Supported Timber Beams: Unified Approach for Test Methods and Structural Design Codes
(American Society of Civil Engineers, 2012)Bearing or compressive-strength capacity perpendicular to the grain of timber beams is a troublesome issue. Not only do many different load cases occur in practice that are not covered by structural timber design codes, ... -
Response of Reinforced Concrete Bridge Columns Subjected to Blast Loads
(American Society of Civil Engineers, 2011)The vast majority of past research on blast-resistant structural design focuses on buildings, with limited attention directed specifically towards bridges. Although many of the same principles apply, bridges pose unique ... -
Reliability-Based Evaluation of U.S. Design Provisions for Composite Steel Deck in Construction Stage
(American Society of Civil Engineers, 2012)This paper presents a reliability-based evaluation of the American National Standards Institute/Steel Deck Institute (ANSI/SDI) C1.0 and Structural Engineering Institute/American Society of Civil Engineers (SEI/ASCE) 37 ... -
Experimental Evaluation of Load Paths in Light-Frame Wood Structure
(American Society of Civil Engineers, 2012)Despite much experience that low-rise wood buildings are vulnerable to damage by extreme wind events, few such structures have been tested in fullsize to understand how they respond to wind loads as a whole system. This ... -
Closed-Form Procedure for Predicting the Capacity and Demand of Steel Beam-Columns under Fire
(American Society of Civil Engineers, 2011)During a fire, columns on the perimeter of a building will be subject to moments induced by both a thermal gradient and the restraint of axial expansion by adjacent heated beams, which themselves develop axial load. These ... -
Modeling Hysteretic Behavior of Wood Shear Walls with a Protocol-Independent Nail Connection Algorithm
(American Society of Civil Engineers, 2012)This paper presents an extension to an algorithm called HYST to develop the hysteresis characteristics of a nail connection. The paper also discusses the implementation of the algorithm in a finite-element model of a wood ...