Journal of Structural Engineering: Recent submissions
Now showing items 4321-4340 of 10765
-
Effects of Pressure Equalization on the Performance of Residential Wall Systems under Extreme Wind Loads
(American Society of Civil Engineers, 2012)During strong windstorms, sheathing and siding on residential, wood-framed, wall systems have commonly failed. In the current study, a clear difference is observed in the rate of failure occurrence for wall sheathing above ... -
Net Section Tension Capacity of Bolted Connections in Cold-Reduced Steel Sheets
(American Society of Civil Engineers, 2012)This paper examines the accuracy of design equations specified in the North American, European and Australasian codes for cold-formed steel structures in determining the net section tension capacity of bolted connections ... -
Closure to “Long-Term Behavior of Composite Beams under Positive and Negative Bending. I: Experimental Study” by Jiansheng Fan, Jianguo Nie, Quanwang Li, and Hao Wang
(American Society of Civil Engineers, 2011) -
Vector Form Intrinsic Finite-Element Analysis of Steel Frames with Semirigid Joints
(American Society of Civil Engineers, 2012)This study uses the vector form intrinsic finite-element (VFIFE) method to investigate the inelastic large deflection behavior of steel frames with semirigid joints. The structural connections are modeled by the two-node, ... -
Block Shear Capacity of Bolted Connections in Cold-Reduced Steel Sheets
(American Society of Civil Engineers, 2012)This paper examines the mechanisms for block shear failures of bolted connections in steel plates postulated in the design equations specified in the North American, European, and Australian steel structures codes. It ... -
Closure to “Progressive Collapse Resistance of Steel-Concrete Composite Floors” by Yasser Alashker, Sherif El-Tawil, and Fahim Sadek
(American Society of Civil Engineers, 2011) -
New Robust Linearized Seismic Analysis Method For Tall Guyed Telecommunication Masts
(American Society of Civil Engineers, 2012)Design of tall telecommunication masts is usually governed by serviceability criteria under high wind conditions, typically combined with icing in cold climates. However, there is a need for seismic design checks for guyed ... -
Collapse Testing and Analysis of a Light-Frame Wood Garage Wall
(American Society of Civil Engineers, 2012)Light-frame wood (woodframe) buildings have been tested at full-scale sparingly around the world, primarily due to the cost associated with such testing and a general lack of facilities large enough to test at system level. ... -
Global Interventions for Seismic Upgrading of Substandard RC Buildings
(American Society of Civil Engineers, 2012)A methodology is developed in this paper for the design and proportioning of interventions for seismic upgrading of substandard reinforced-concrete (RC) buildings. The retrofit approach is presented in the form of a simple ... -
Seismic Performance of Buckling-Restrained Braced Frames with Eccentric Configurations
(American Society of Civil Engineers, 2012)Braced frames are often used to resist lateral earthquake loads in steel buildings, but braces can interfere with architectural features. Eccentrically braced frames (EBFs) will accommodate windows, doors, and halls, but ... -
Discussion of “Behavior of Prestressed Steel Beams” by B. Belletti and A. Gasperi
(American Society of Civil Engineers, 2012) -
Summary Review of GPS Technology for Structural Health Monitoring
(American Society of Civil Engineers, 2013)Over the last two decades, global positioning system (GPS) technology has been developed rapidly and recently applied to civil structures for appropriate monitoring of structural performance. Currently, the GPS technique ... -
Flexural Behavior of Concrete-Filled Circular Steel Tubes under High-Strain Rate Impact Loading
(American Society of Civil Engineers, 2012)Nine simply supported circular steel concrete-filled tubes (CFTs), two circular steel posttensioned concrete-filled tubes (PTCFTs), and one circular steel fiber–reinforced concrete-filled tube (FRCFT) have been tested in ... -
Concrete Stress Distribution Factors for High-Performance Concrete
(American Society of Civil Engineers, 2012)Most of the existing codes are using stress-block parameters which were derived for normal strength concrete. Several researchers in the past have reported that use of ACI 318 stress-block parameters results in un-conservative ... -
Modeling of RC Shear Walls Retrofitted with Steel Plates or FRP Sheets
(American Society of Civil Engineers, 2012)Advancements in the nonlinear finite-element method have resulted in reliable simulations of response for reinforced concrete (RC) structures, provided that an analysis program with comprehensive models for material and ... -
Tensile Strength of Varied-Angle Mortise and Tenon Connections in Timber Frames
(American Society of Civil Engineers, 2012)The tensile strength of varied-angle mortise and tenon connections in timber frames is discussed in this paper. Twelve full-size mortise and tenon connections (four 90°, four 67.5°, and four 45°) were tested under monotonic ... -
Inelastic Bending Capacity of Cold-Formed Steel Members
(American Society of Civil Engineers, 2012)The objective of this paper is to provide and verify a general design method for prediction of inelastic bending capacity in cold-formed steel members potentially subject to local, distortional, and/or lateral-torsional ... -
Collapse Behavior of Composite Plate Girders Loaded in Shear
(American Society of Civil Engineers, 2012)This paper is concerned with the ultimate shear capacity of steel-concrete composite plate girders in which one of the flanges of the steel girder is connected to reinforced concrete slab through shear connectors so that ... -
Closure to “Tornado-Induced Wind Loads on a Low-Rise Building” by F. L. Haan Jr., Vasanth Kumar Balaramudu, and P. P. Sarkar
(American Society of Civil Engineers, 2011)