Journal of Structural Engineering: Recent submissions
Now showing items 3881-3900 of 10765
-
Editor’s Note
(American Society of Civil Engineers, 2010) -
Closure to “Uniaxial Shear-Flexure Model for Reinforced Concrete Elements” by H. Mostafaei and F. J. Vecchio
(American Society of Civil Engineers, 2010) -
Discussion of “Analytical Model of Ground Motion Pulses for the Design and Assessment of Seismic Protective Systems” by W.-L. He and A. K. Agrawal
(American Society of Civil Engineers, 2010) -
Discussion of “Determination of Composite Slab Strength Using a New Test Method” by Redzuan Abdullah and W. Samuel Easterling
(American Society of Civil Engineers, 2010) -
Closure to “Equivalent Static Wind Loads on Long-Span Roof Structures” by J. Fu, Z. Xie, and Q. S. Li
(American Society of Civil Engineers, 2010) -
Design Wind Loads Including Torsion for Rectangular Buildings with Horizontal Aspect Ratio of 1.6
(American Society of Civil Engineers, 2014)Limited information is available regarding wind-induced torsional loads on buildings. This paper presents results of tests carried out in a boundary-layer wind tunnel using building models with the same plan dimensions ... -
Closure to “Active Shear Planes of Bolted Connections Failing in Block Shear” by Drew D. A. Clements and Lip H. Teh
(American Society of Civil Engineers, 2014) -
Flexural Tests and Associated Study of a Full-Scale 65-kW Wind Turbine Tower
(American Society of Civil Engineers, 2014)Full-scale static test to failure was conducted on a 21.9-m-long 65-kW wind turbine tower to evaluate the flexural strength and failure mode. The test was conducted in a displacement-control mode. The flexural limit state ... -
Analytical Element for Simulating Lateral-Strength Degradation in Reinforced Concrete Columns and Other Frame Members
(American Society of Civil Engineers, 2014)An analytical element is proposed that is capable of simulating the lateral-strength degradation behavior of frame members subjected to seismic loading up to severe loss in lateral strength. Although element capabilities ... -
Influence of Flexibility on the Fatigue Performance of the Base Plate Connection in High-Mast Lighting Towers
(American Society of Civil Engineers, 2010)This study investigates the effect of base connection geometry on base plate flexibility and the fatigue performance of multisided high-mast lighting towers. Three parametric studies investigating the effect of base plate ... -
Discussion of “Active Shear Planes of Bolted Connections Failing in Block Shear” by Drew D. A. Clements and Lip H. Teh
(American Society of Civil Engineers, 2014) -
Distortional Buckling of Cold-Formed Steel Shear Wall Studs under Uplift Force
(American Society of Civil Engineers, 2010)A cold-formed steel framed shear wall may fail in shear buckling of the sheathing, local buckling or distortional buckling of the framing member under compression forces or connection failures. An unusual distortional ... -
Analysis of Wind-Induced Clip Loads on Standing Seam Metal Roofs
(American Society of Civil Engineers, 2010)The current investigation extends the previous work in calculating components and cladding loads for standing seam metal roof clips. It was found that the ASCE 7-05 wind loads for these clips are conservative, while several ... -
Finite-Element Modeling of Nonlinear Behavior of Masonry-Infilled RC Frames
(American Society of Civil Engineers, 2010)The evaluation of the seismic performance of masonry-infilled reinforced concrete (RC) frames has been a major challenge for structural engineers. This paper addresses pertinent issues on the development and calibration ... -
Effects of Incident Flows on Wind Loads and Their Combinations on a Low-Rise Building Immersed in a Long Upstream Fetch
(American Society of Civil Engineers, 2014)The primary purpose of the present study was to investigate the effect of incident flows (i.e., variations in terrain roughness) on wind loads and wind load combination effects on a target low-rise building. Three area ... -
Generalized Response Surface Model Updating Using Time Domain Data
(American Society of Civil Engineers, 2014)In finite-element (FE) model updating using response surface (RS) models as surrogate, the procedure of finding an appropriate design to build the RS models requires a number of trial-and-error approaches with different ... -
Analysis of Segmentally Constructed Prestressed Concrete Bridges Using Hexahedral Elements with Realistic Tendon Profiles
(American Society of Civil Engineers, 2014)The paper presents a systematically numerical procedure based on the finite-element method for three-dimensional analysis of segmentally constructed prestressed concrete bridges using hexahedral elements including realistic ... -
Dynamic Response of Steel Columns Subjected to Blast Loading
(American Society of Civil Engineers, 2014)In this study, 13 typical wide-flange steel columns, each carrying an axial load equal to 25% of its axial capacity, are field tested using live explosives, involving charge size of 50 to 250 kg of ammonium nitrate/fuel ... -
Robust Design of Tuned Mass Damper Systems for Seismic Protection of Multistory Buildings
(American Society of Civil Engineers, 2014)In this paper, a method is proposed for the robust design of tuned mass damper (TMD) systems for seismic protection of multistory buildings. The seismic excitation is a random ground motion acceleration modeled by a ... -
Computational Simulation of a Full-Scale, Fixed-Base, and Isolated-Base Steel Moment Frame Building Tested at E-Defense
(American Society of Civil Engineers, 2014)A full-scale earthquake simulation of a five-story steel moment frame building at E-Defense, the world’s largest single shake table facility in Miki, Japan, in August 2011 provided realistic data to improve and validate ...