Journal of Structural Engineering: Recent submissions
Now showing items 3021-3040 of 10765
-
Seismic Response Analysis of Lightly Reinforced Concrete Block Masonry Shear Walls Based on Shake Table Tests
(American Society of Civil Engineers, 2014)This paper presents detailed analyses of experimental shake table test results with the goal of providing a better understanding of the seismic performance of lightly reinforced fully grouted masonry shear walls. The paper ... -
Structural Identification of a Nonproportionally Damped System and Its Application to a Full-Scale Suspension Bridge
(American Society of Civil Engineers, 2005)Ambient vibration measurement is an important tool to evaluate the integrity of in-service structures. The writers apply a new structural identification method to ambient vibration data taken from a full-scale suspension ... -
Closure to “<i>Finite Element Modeling of Concrete Expansion and Confinement</i>” by F. J. Vecchio (September, 1992, Vol. 118, No. 9)
(American Society of Civil Engineers, 1994) -
Seismic Loss and Downtime Assessment of Existing Tall Steel-Framed Buildings and Strategies for Increased Resilience
(American Society of Civil Engineers, 2016)In areas of high seismicity in the United States, the design of many existing tall buildings followed guidelines that do not provide an explicit understanding of performance during major earthquakes. This paper presents ... -
Beyond Ductility: Parametric Testing of a Jointed Rocking Beam-Column Connection Designed for Damage Avoidance
(American Society of Civil Engineers, 2016)Despite their good performance in terms of their design objectives, many modern code-prescriptive buildings built in Christchurch, New Zealand, had to be razed after the 2010–2011 Canterbury earthquakes because repairs ... -
Quantifying Changes in Structural Design Needed to Account for Aftershock Hazard
(American Society of Civil Engineers, 2015)Aftershocks have the potential to cause severe damage to buildings and threaten life following a major earthquake. However, their effect on seismic hazards is not explicitly accounted for in modern building design codes, ... -
In Situ Out-of-Plane Testing of As-Built and Retrofitted Unreinforced Masonry Walls
(American Society of Civil Engineers, 2014)The out-of-plane behavior of as-built and retrofitted unreinforced masonry (URM) walls was investigated by conducting in situ static airbag tests in four buildings. The age of the buildings varied from 80 to 130 years, and ... -
Closure to “<i>Evaluation of Building Code Formulas for Earthquake Forces</i>” by Anil K. Chopra and Ernesto F. Cruz (August 1986, Vol. 112, No. 8)
(American Society of Civil Engineers, 1988) -
Closure to “<i>Extreme Thermal Loadings in Highway Bridges</i>” by Duen Ho and Chi‐Ho Liu (May, 1989, Vol. 115, No. 7)
(American Society of Civil Engineers, 1991) -
Closure to “<i>Structural Seismic Damper</i>” by Manuel Aguirre and A. Roberto Sánchez (May, 1992, Vol. 118, No. 5)
(American Society of Civil Engineers, 1993) -
Seismic Performance of High-Strength Concrete Columns
(American Society of Civil Engineers, 1998)This paper presents the experimental results of six scaled high-strength concrete columns with concrete compressive strengths of 76–86 MPa. Primary experimental parameters include axial loads ranging from 10 to 20% of ... -
Closure to “<i>Loads Due to Spectator Movements</i>” by Christopher Y. Tuan and William E. Saul (February, 1985, Vol. 111, No. 2)
(American Society of Civil Engineers, 1987) -
Behavior and Design of Concentrically Loaded T-Section Steel Columns
(American Society of Civil Engineers, 2014)The buckling behavior of T-section columns is discussed in detail, followed by a numerical study using geometric and material nonlinear analyses (GMNIA) to produce column strengths for a wide range of geometries of T-sections ... -
Editor's Note
(American Society of Civil Engineers, 2000) -
Discussion: Gabled Hyperbolic Paraboloid Roofs without Edge Beams
(American Society of Civil Engineers, 1996) -
Inelastic Modeling and Seismic Energy Dissipation
(American Society of Civil Engineers, 1987)The influence of inelastic load-deformation behavior on seismic energy imparted and dissipated is assessed. Stiffness degrading and bilinear hysteretic models are considered. The load-deformation model has a pronounced ... -
Discussion of “<i>Checking Models in Structural Design</i>” by Mark G. Stewart and Robert E. Melchers (June, 1989, Vol. 115, No. 6)
(American Society of Civil Engineers, 1991) -
Design of Prestressed Hollow Core Slabs with Reference to Web Shear Failure
(American Society of Civil Engineers, 1994)A design procedure to determine the capacity against shear failure of webs of prestressed hollow core slabs is presented. The additional shear stresses in webs caused by prestress forces of strands have been taken into ... -
Closure to “<i>Design of Timber Beams: A Graphical Approach</i>” by Shan Somayaji (January, 1983)
(American Society of Civil Engineers, 1984) -
Dynamic Characterization of a Soft Elastomeric Capacitor for Structural Health Monitoring
(American Society of Civil Engineers, 2015)Structural health monitoring of civil infrastructures is a difficult task, often impeded by the geometrical size of the monitored systems. Recent advances in conducting polymers enabled the fabrication of flexible sensors ...