Journal of Structural Engineering: Recent submissions
Now showing items 1201-1220 of 10765
-
State Estimation for Prediction of Fatigue Life for a Rollercoaster Connection Subjected to Operational Multiaxial Nonproportional Loading
(ASCE, 5/1/2021)Recent research on structural health monitoring has shown the applicability of Kalman filtering for fusion of models and data of dynamic systems. In this study, the augmented Kalman filter (AKF) is combined with a ... -
Contribution of Partition Walls in Lateral Load–Resisting Systems of Low-Rise Light Wood Frame Buildings
(ASCE, 4/1/2021)Prescriptive design is a common practice in North America for low-rise light wood frame buildings. The prescriptive wood-based shear wall details provided in building codes to resist lateral loads were largely derived based ... -
Incorporating Frame Action into Seismic Design of Gusset Plates
(ASCE, 3/1/2021)Gusset plates connect the brace and frame in concentrically braced frames (CBFs). Failure at the interface of gusset plates with the beam or column will result in an inability to achieve energy dissipation through brace ... -
Seismic Performance of Welded Stainless Steel H-Section Columns under Cyclic Horizontal Loading
(ASCE, 4/1/2021)This study investigated the seismic performance of welded stainless steel H-section columns. Ten columns were tested under cyclic horizontal load; their seismic performance was analyzed according to their hysteresis curves, ... -
Development of Inelastic Panel Zone Database
(ASCE, 4/1/2021)This data paper reviews the experimental research on fully restrained beam-to-column connections for steel moment-resisting frames (MRFs) over the last 50 years worldwide and presents an experimental database consisting ... -
Cyclic Behavior of Perfobond-Shear Connectors Subjected to Fully Reversed Cyclic Loading
(ASCE, 3/1/2021)In general, a steel beam is assembled with a concrete slab using shear connectors. Recently, perfobond-shear connectors have been attracting interest because of their high shear stiffness and strength. Nevertheless, the ... -
Data-Based Windstorm Type Identification Algorithm and Extreme Wind Speed Prediction
(ASCE, 5/1/2021)The extreme wind speed estimation method, which is critical for designing wind load calculation for building structures, should consider windstorm climate types for mixed climates. However, it is very difficult to obtain ... -
Uniform Design–Based Gaussian Process Regression for Data-Driven Rapid Fragility Assessment of Bridges
(ASCE, 4/1/2021)This paper proposes a uniform design (UD)-based Gaussian process regression (GPR) method for rapid damage assessment and fragility estimates of bridges. The core idea of the proposed method is that the GPR model was adopted ... -
Seismic Performance of a Long-Span Cable-Stayed Bridge under Spatially Varying Bidirectional Spectrum-Compatible Ground Motions
(ASCE, 4/1/2021)Considering the socioeconomic prominence of long-span cable-stayed bridges, it is important to ensure their normal operation after strong earthquake events. To this end, their seismic performance must be based on a proper ... -
Design of Lean Duplex Stainless Steel Tubular Sections Subjected to Concentrated End-Bearing Loads
(ASCE, 4/1/2021)This study presents the numerical investigation and design of cold-formed lean duplex stainless steel (CFLDSS) tubular sections subjected to concentrated end bearing loads, specifically end-one-flange (EOF), end-two-flange ... -
Detection of Top-Bar Effect in Reinforced Concrete Using Guided Ultrasonic Waves
(ASCE, 4/1/2021)An ultrasonic shear wave-based nondestructive method is proposed in this paper to detect steel–concrete interface debonding owing to the top-bar effect. A concrete wall was cast with horizontal reinforcements at different ... -
Two-Dimensional Aerodynamic Admittance of a Flat Closed-Box Bridge
(ASCE, 3/1/2021)Wind tunnel tests were carried employing two different free-stream turbulent flow fields and one harmonic vertical gust profile conditions, and pressure measurements of the buffeting force on six separated strips of a flat ... -
Equivalent Viscous Damping of Cross-Laminated Timber Structural Archetypes
(ASCE, 4/1/2021)This paper attempts to formulate an expression for the estimation of equivalent viscous damping (EVD) for cross-laminated timber (CLT) structural archetypes as a function of ductility. The paper aims at contributing toward ... -
Data Set for Cyclic Tests of Eleven Lightly Reinforced Concrete Walls
(ASCE, 3/1/2021)A series of reinforced concrete wall tests were conducted at the University of Auckland to address the lack of experimental data on flexure-dominant lightly reinforced concrete walls that are common in multistorey buildings ... -
Development of a Novel V-D Strut Model for Seismic Analysis of Confined Masonry Buildings
(ASCE, 3/1/2021)Confined masonry (CM) offers an affordable and seismically safe building typology, which is already a widespread construction technique in several seismically-prone countries, and is currently evolving as a popular ... -
Structural Behavior of Masonry Beams with Alternative Shear Reinforcement
(ASCE, 3/1/2021)Shear reinforcement, or stirrups, for reinforced masonry beams made of concrete blocks are placed inside the cells of the units. Since it is a requirement by masonry standards for shear stirrups to hook around the longitudinal ... -
Punching Shear Strength Model for Reinforced Concrete Flat Plate Slab–Column Connection without Shear Reinforcement
(ASCE, 3/1/2021)Many existing studies on punching shear in a RC flat plate slab without shear reinforcement consider uncracked concrete in the compression zone or the aggregate interlock mechanism in the cracked tension zone as shear ... -
System Identification of UCSD-NHERI Shake-Table Test of Two-Story Structure with Cross-Laminated Timber Rocking Walls
(ASCE, 4/1/2021)A full-scale 2-story mass timber building was tested on the University of California San Diego Natural Hazards Engineering Research Infrastructure (UCSD-NHERI) uniaxial shake table during the period from June 2017 to ... -
Structural Behavior of Screwed Connections in Cold-Formed Steel Beams
(ASCE, 3/1/2021)Two test series were carried out on angle cleat connections between cold-formed channels as beams and rectangular hollow sections as support members. The objective of the tests was to determine the effect of connection ... -
Seismic Loss Estimation Using Visual Damage Models
(ASCE, 3/1/2021)This paper presents models for visual damage, together with a methodology for seismic loss estimation based on that type of damage prediction. The methodology predicts repair cost, duration, and labor hours. The visual ...