Journal of Composites for Construction: Recent submissions
Now showing items 2041-2060 of 2137
-
Effect of Short-Term Freeze-Thaw Cyclingon Composite Confined Concrete
(American Society of Civil Engineers, 2000)Concrete cylinders jacketed with glass and carbon-fiber-reinforced polymer (FRP) composites were exposed to 201 freeze-thaw cycles, and results of compression response were compared with results from similar specimens kept ... -
Load-Deflection Analysis of FRP Reinforced Concrete Flexural Members
(American Society of Civil Engineers, 2000)This paper is devoted to the deformability investigation of concrete flexural members reinforced with fiber-reinforced polymer (FRP) rebars. The analysis is carried out both theoretically, by means of a general procedure ... -
Bond to Concrete of FRP Rebars after Cyclic Loading
(American Society of Civil Engineers, 2000)The bond mechanism of fiber-reinforced polymer (FRP) rebars to concrete was studied to evaluate the effect of cyclic loading. Five different types of 12.0- and 12.7-mm rebars were tested. The FRP rods were embedded in ... -
Modeling Out-of-Plane Behavior of URM Walls Retrofitted with Fiber Composites
(American Society of Civil Engineers, 2000)Although masonry is one of the oldest construction materials, its behavior has not been investigated as extensively as other construction materials. Out-of-plane failures are common in unreinforced masonry (URM) buildings ... -
Experimental Response and Code Modelsof GFRP RC Beams in Bending
(American Society of Civil Engineers, 2000)The use of composite materials in structural engineering is recent, and researchers need to investigate their behavioral features. Design criteria and methods have to be redefined, and several countries have already ... -
Mechanical Interaction between Concrete and FRP Sheet
(American Society of Civil Engineers, 2000)In this technical note, fiber-reinforced plastics (FRP) strengthening efficiency for reinforced-concrete columns will be examined from a micromechanical point of view by accounting for direct mechanical interaction between ... -
Construction of a Pultruded Composite Structure: Case Study
(American Society of Civil Engineers, 2000)In a recent research and development project a novel prototype pultruded composite structure was designed, fabricated, and tested. The bargelike, box-girder type structure measured approximately 24-ft long by 15-ft wide ... -
Assessment of Life-Cycle Benefit-Cost of Composites in Construction
(American Society of Civil Engineers, 2000)So far, composite materials have found only moderate acceptance in the construction industry. This has been due primarily to technical and economic barriers such as limited information on life-cycle costs and anticipated ... -
Retrofitting of Deficient RC Cantilever Slabs Using GFRP Strips
(American Society of Civil Engineers, 2000)Despite many studies on beams and slabs strengthened using fiber-reinforced plastic (FRP) plates, no study has been reported on the strengthening of RC cantilever slabs (e.g., canopies and balconies) using FRP materials. ... -
Deformation in Concrete with External CFRP Sheet Reinforcement
(American Society of Civil Engineers, 2000)A detailed experimental investigation of local and global deformations of tensile-loaded, cracked, rectangular, concrete prisms reinforced with externally bonded carbon fiber reinforced polymer (CFRP) sheets was carried ... -
Laboratory and Field Testing of Composite Bridge Superstructure
(American Society of Civil Engineers, 2000)Bridge rehabilitation utilizing a hybrid fiber-reinforced polymeric composite has recently been completed in Blacksburg, Va. This project involved replacing the superstructure in the Tom's Creek Bridge, a rural short-span ... -
Performance of Tube and Plate Fiberglass Composite Bridge Deck
(American Society of Civil Engineers, 2000)A composite bridge deck system assembled from glass/polyester pultruded components has been developed. This system utilizes square tubes running transverse to the traffic direction, mechanically fastened and bonded together, ... -
Axial Testing of Rectangular Column Models Confined with Composites
(American Society of Civil Engineers, 2000)Recent evaluation of civil engineering infrastructure has demonstrated that most of it will need major repairs in the near future. This justifies the development of innovative rehabilitation and strengthening methods for ... -
Shear Strengthening of RCT-Joints Using CFRP Composites
(American Society of Civil Engineers, 2000)The rehabilitation of RC columns jacketed with carbon fiber-reinforced plastic (FRP) composites for improving shear strength, confinement, and ductility has received considerable attention. However, research for improving ... -
Closed-Form High-Order Analysis of RC Beams Strengthened with FRP Strips
(American Society of Civil Engineers, 2000)A closed-form high-order analytical solution for the analysis of concrete beams strengthened with externally bonded fiber-reinforced plastic (FRP) strips is presented. The model is based on equilibrium and deformations ... -
Local Bond-Slip Relationship for FRP Reinforcement in Concrete
(American Society of Civil Engineers, 2000)The objective of this paper is to define a rigorous numerical method to calibrate parameters of a given local bond-slip relationship using experimental results of pullout tests, taking into account the distribution of the ... -
Design and Installation of Fiber-Reinforced Polymer Composite Bridge
(American Society of Civil Engineers, 2000)This report describes the installation and testing of a fiber-reinforced polymer composite highway bridge located in Butler County, Ohio. The bridge was designed to meet AASHTO HS-20 load requirements based on strength and ... -
Beam-Column Design Equations for Wide-Flange Pultruded Structural Shapes
(American Society of Civil Engineers, 1999)A simple procedure is developed for the selection of pultruded structural shapes to be used as beam-columns in structural design. The design equations are then validated by comparison with experimental data gathered during ... -
Service and Ultimate Load Behavior of Bridge Deck Reinforced with Carbon FRP Grid
(American Society of Civil Engineers, 2000)A full-scale model of a bridge deck slab isotropically reinforced with 0.3% fiber-reinforced plastic reinforcement (FRP) was tested. The 6 m long slab of 185 mm thickness had two 2 m spans and 1 m cantilevers on both sides. ... -
Closure to “Quality Assurance of GFRP Pipes for Seawater Cooling of Power Plants” by O. Ishai
(American Society of Civil Engineers, 2000)