Now showing items 2061-2080 of 2137

    • Canadian Bridge Design Code Provisions for Fiber-Reinforced Structures 

      Baidar Bakht; George Al-Bazi; Nemy Banthia; Moe Cheung; Marie-Anne Erki; Martin Faoro; Atsuhiko Machida; Aftab A. Mufti; Kenneth W. Neale; Gamil Tadros (American Society of Civil Engineers, 2000)
      This paper presents a synthesis of the design provisions of the Canadian Highway Bridge Design Code for fiber-reinforced structures. These include structures reinforced with fiber-reinforced polymer and fiber-reinforced ...
    • Quality Assurance of GFRP Pipes for Seawater Cooling of Power Plants 

      Hayder A. Rasheed; O. Ishai (American Society of Civil Engineers, 2000)
    • Editor's Note 

      Lawrence C. Bank, Editor-in-Chief (American Society of Civil Engineers, 2000)
    • Prediction of Tensile Capacity of Bond Anchorages for FRP Tendons 

      Burong Zhang; Brahim Benmokrane; Adil Chennouf (American Society of Civil Engineers, 2000)
      Past test data show that the bond stress distribution of bond anchorages is nonuniform along the bonded length and that the point of the peak bond strength shifts from the entry of the tendon to an inside point of the ...
    • Behavior of Retrofitted URM Walls under Simulated Earthquake Loading 

      M. R. Ehsani; H. Saadatmanesh; J. I. Velazquez-Dimas (American Society of Civil Engineers, 1999)
      Unreinforced masonry (URM) buildings perform poorly under seismic forces and have been identified as the main cause of loss of life in recent earthquakes. Many of these structures fail in out-of-plane bending due to the ...
    • Book Review: Introduction to Composite Materials Design 

      Pizhong Qiao and Julio F. Davalos (American Society of Civil Engineers, 1999)
    • Slip Modulus of FRP Sheets Bonded to Concrete 

      Y. J. Lee; T. E. Boothby; C. E. Bakis; A. Nanni (American Society of Civil Engineers, 1999)
      An analytical tension-stiffening model was developed for fiber-reinforced polymer (FRP) sheets bonded to reinforced concrete based on equilibrium equations and the assumption of linear behavior between bond stress and slip. ...
    • Impact Loading of Concrete Beams Externally Strengthened with CFRP Laminates 

      M. A. Erki; U. Meier (American Society of Civil Engineers, 1999)
      The quasi-static behavior of flexural members strengthened with carbon fiber reinforced polymer (CFRP) laminates has been well documented in recent years, but there is a gap in knowledge regarding the effects of dynamic ...
    • FRP-Confined Concrete Model 

      Marijn R. Spoelstra; Giorgio Monti (American Society of Civil Engineers, 1999)
      A uniaxial model for concrete confined with fiber-reinforced polymers (FRP), but also with steel jackets or conventional transverse reinforcement, is presented. The model, which is suitable to be inserted into fiber-type ...
    • Experimental Results on Centrifugated GFRP Poles for Electric Lifelines 

      Carlo Castiglioni; Maura Imbimbo (American Society of Civil Engineers, 1999)
      In this paper the results of an experimental investigation on glass fiber reinforced plastic (GFRP) centrifugated transmission utility poles are discussed. The study is principally aimed to analyze the effect of manufacturing ...
    • Transfer Lengths and Bond Strengths for Composites Bonded to Concrete 

      L. Bizindavyi; K. W. Neale (American Society of Civil Engineers, 1999)
      An effective method for strengthening existing concrete beams in bending consists in bonding fiber-reinforced composite laminates on the tension faces of the beams. Laboratory tests on beam specimens show, however, that ...
    • Bond Length of CFRP Composites Attached to Precast Concrete Walls 

      Vladimir A. Volnyy; Chris P. Pantelides (American Society of Civil Engineers, 1999)
      Carbon fiber composite connections for hollow-core precast concrete wall panels have been investigated with respect to bond behavior. A panel assembly made up of three precast concrete walls was loaded in the in-plane ...
    • Failure of Web-Flange Junction in Postbuckled Pultruded I-Beams 

      Lawrence C. Bank; Jianshen Yin (American Society of Civil Engineers, 1999)
      A numerical procedure for analyzing a common and catastrophic failure mode in pultruded composite material I-beams is presented in this paper. Pultruded wide-flange profiles (often referred to as I-beams) exhibit a number ...
    • The Clear Creek Hybrid Composite I-Girder Pedestrian Bridge 

      P. J. Szak; B. N. Robson; I. E. Harik; B. Brailsford (American Society of Civil Engineers, 1999)
      An 18.3 m (60 ft) pedestrian I-girder bridge was analyzed, designed, tested, and constructed. The main load-carrying members for the bridge are two 61-cm (24-in.) deep composite fiberglass I-girders with embedded carbon ...
    • Effect of High Temperature on Bond Strength of FRP Rebars 

      Ammon Katz; Neta Berman; Lawrence C. Bank (American Society of Civil Engineers, 1999)
      The bond properties of fiber reinforced polymer (FRP) reinforcing bars (rebars) at temperatures ranging from room temperature (20°C) to high temperatures of up to 250°C are discussed in this paper. The bond properties in ...
    • Deflection Control of Concrete Beams Pretensioned by CFRP Reinforcements 

      Amr A. Abdelrahman; Sami H. Rizkalla (American Society of Civil Engineers, 1999)
      Use of carbon fiber reinforced polymers (CFRP) reinforcement for prestressing concrete structures introduces a promising solution for deterioration of concrete structures due to corrosion of steel reinforcements. Due to ...
    • Tensile Durability of Cement-Based FRP Composite Wrapped Specimens 

      Houssam A. Toutanji; Tahar El-Korchi (American Society of Civil Engineers, 1999)
      Fiber-reinforced polymer composite (FRPC) wraps are increasingly being used for rehabilitation and strengthening of concrete structures. This paper presents the results of an experimental study on the tensile performance ...
    • Thermal Compatibility of Concrete and Composite Reinforcements 

      T. Russell Gentry; Mohamed Husain (American Society of Civil Engineers, 1999)
      Experiments on commercially-produced composite reinforcements have shown that the transverse coefficients of thermal expansion (CTE) of these rebar are 3–5 times higher than the CTE of concrete. In this paper, thermoelastic ...
    • Fatigue Performance of Concrete Beams Strengthened with CFRP Plates 

      Richard Andrew Barnes; Geoffrey Charles Mays (American Society of Civil Engineers, 1999)
      Recent increases in bridge design loading requirements have highlighted the need for fast, efficient, and durable strengthening methods. External steel plate bonding provides a satisfactory solution, but carbon fiber ...
    • Concrete Cover Failure in FRP Reinforced Beams under Thermal Loading 

      Maria Antonietta Aiello (American Society of Civil Engineers, 1999)
      The use of fiber reinforced polymer (FRP) rebars as a substitute for traditional steel rebars represents a very effective solution for reinforced concrete structures in corrosive environments. However, a better understanding ...