On Wedge Indentation and Its Relationship With Incipient Plastic Deformation in Metal CuttingSource: Journal of Manufacturing Science and Engineering:;1977:;volume( 099 ):;issue: 003::page 702Author:K. J. Weinmann
DOI: 10.1115/1.3439301Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper deals with plane strain indentation of annealed brass by both symmetric and half wedges, and the connection between wedge indentation and incipient chip formation by a positive rake angle tool. Indentation forces and wedge-plate contact lengths were measured, and plastic deformation underneath the indenters was studied by microhardness scanning and discussed. Half-wedge indentations at decreasing distances from the plate corner were shown to result in a transition from wedge indentation to chip formation.
keyword(s): Metal cutting , Deformation , Wedges , Force , Brass (Metal) , Corners (Structural elements) , Microhardness AND Plane strain ,
|
Collections
Show full item record
| contributor author | K. J. Weinmann | |
| date accessioned | 2017-05-08T23:03:23Z | |
| date available | 2017-05-08T23:03:23Z | |
| date copyright | August, 1977 | |
| date issued | 1977 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27662#702_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/90191 | |
| description abstract | This paper deals with plane strain indentation of annealed brass by both symmetric and half wedges, and the connection between wedge indentation and incipient chip formation by a positive rake angle tool. Indentation forces and wedge-plate contact lengths were measured, and plastic deformation underneath the indenters was studied by microhardness scanning and discussed. Half-wedge indentations at decreasing distances from the plate corner were shown to result in a transition from wedge indentation to chip formation. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | On Wedge Indentation and Its Relationship With Incipient Plastic Deformation in Metal Cutting | |
| type | Journal Paper | |
| journal volume | 99 | |
| journal issue | 3 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.3439301 | |
| journal fristpage | 702 | |
| journal lastpage | 707 | |
| identifier eissn | 1528-8935 | |
| keywords | Metal cutting | |
| keywords | Deformation | |
| keywords | Wedges | |
| keywords | Force | |
| keywords | Brass (Metal) | |
| keywords | Corners (Structural elements) | |
| keywords | Microhardness AND Plane strain | |
| tree | Journal of Manufacturing Science and Engineering:;1977:;volume( 099 ):;issue: 003 | |
| contenttype | Fulltext |