Induced-Partial Saturation for Liquefaction Mitigation: Experimental Investigation

Abstract

The technical feasibility of a new liquefaction mitigation technique is investigated by introducing small amounts of gas/air into liquefaction-susceptible soils. To explore this potential beneficial effect, partially saturated sand specimens were prepared and tested under cyclic shear strain controlled tests. A special flexible liquefaction box was designed and manufactured that allowed preparation and testing of large loose sand specimens under applied simple shear. Partial saturation was induced in various specimens by electrolysis and alternatively by drainage-recharge of the pore water. Using a shaking table, cyclic shear strain controlled tests were performed on fully and partially saturated loose sand specimens to determine the effect of partial saturation on the generation of excess pore water pressure. In addition, the use of cross-well radar in detecting partial saturation was explored. Finally, a setup of a deep sand column was prepared and the long-term sustainability of air entrapped in the voids of the sand was investigated. The results show that partial saturation can be achieved by gas generation using electrolysis or by drainage-recharge of the pore water without influencing the void ratio of the specimen. The results from cyclic tests demonstrate that a small reduction in the degree of saturation can prevent the occurrence of initial liquefaction. In all of the partially saturated specimens tested, the maximum excess pore pressure ratios ranged between 0.43 and 0.72. Also, the cross-well radar technique was able to detect changes in the degree of saturation when gases were generated in the specimen. Finally, monitoring the degree of partial saturation in a