Show simple item record

contributor authorHuey, Carolyn
contributor authorMetghalchi, Hameed
contributor authorLevendis, Yiannis
date accessioned2024-12-24T18:52:56Z
date available2024-12-24T18:52:56Z
date copyright7/5/2024 12:00:00 AM
date issued2024
identifier issn2770-3495
identifier otheraoje_3_031017.pdf
identifier urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4302916
description abstractSynthetic “E-fuels,” or electro-fuels, have been introduced as a potential reduced carbon emissions energy source for power generation and vehicle propulsion applications. Environmental change is needed, with the transportation sector alone producing approximately a quarter of global greenhouse gas (GHG) emissions. Hydrogen, produced from electrolysis to avoid GHG production, is used along with CO2 or nitrogen to generate these electro-fuels, through the Fischer–Tropsch process. Direct air capture (DAC) of atmospheric carbon dioxide or biomass combustion effluents can provide sources for these gases to be combined with hydrogen to generate synthetic methanol, methane, or ammonia—the three most widely discussed E-fuels. In addition, “ER-fuels,” or electrically reformed fuels, are a similar option to E-fuels, where refinery fuel gases, such as ethane or propane, are reformed before synthesis to produce the final fuel. E-fuels, on the other hand, are generated from hydrogen and carbon either captured or produced, not from existing fuels. Redox couples, such as vanadium, can additionally be used as zero emission fuels; they are “electrically rechargeable” in that, through electrolysis, the reducing agent is produced, and then using a fuel cell (FC), the reverse occurs, and electrons plus the oxidizing agent are produced. These synthetic fuels are approximately carbon neutral when the hydrogen is sourced from renewable powered electrolysis, mainly solar and wind energy, as the amount of carbon dioxide consumed is roughly equivalent to the amount produced upon their combustion or FC energy conversion. Combustion in gas turbines or reciprocating piston-cylinder engines and FC electricity generation are the two main uses for extracting energy from E-fuels. Fuel cells are shown to have higher efficiency, but combustion provides fewer infrastructure changes and easier implementation. Both options provide a method for controlling carbon emissions using E-fuels as opportunities for energy storage.
publisherThe American Society of Mechanical Engineers (ASME)
titleE-Fuels as Reduced Carbon Emission Options
typeJournal Paper
journal volume3
journal titleASME Open Journal of Engineering
identifier doi10.1115/1.4065731
journal fristpage31017-1
journal lastpage31017-5
page5
treeASME Open Journal of Engineering:;2024:;volume( 003 ):;issue: 00
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record