Critical Heat Flux Condition and Post-Critical Heat Flux Heat Transfer of Carbon Dioxide at High Reduced Pressures in a Microchannel

Abstract

Flow boiling heat transfer around the critical heat flux (CHF) condition at high reduced pressures of carbon dioxide in a 296-μm hydraulic diameter microchannel was experimentally studied. The CHF conditions for developing flow and fully developed flow were measured and compared to established correlations. The post-CHF heat transfer coefficient was obtained for l/d of 3.2, 7.4, and 11.6 for inlet Reynolds numbers, based on the homogeneous two-phase flow model, ranging from 6622 to 32,248. The critical heat flux conditions seemed to peak around a reduced pressure of about 0.5 and gradually decreased with reduced pressure. However, the typical rapid increase in the surface temperature following the CHF condition decreased with increasing pressure, and the post-CHF heat transfer coefficient was appreciably high (up to about 50 kW/m2K) at high reduced pressures. The enhancement in the heat transfer coefficient and CHF condition near the inlet were quantified. The experimental results were compared to established CHF correlations and heat transfer coefficient correlations with some limited success. Thus, the Katto CHF correlation (Katto and Ohno, 1984, “An Improved Version of the Generalized Correlation of Critical Heat Flux for the Forced Convective Boiling in Uniformly Heated Vertical Tubes,” Int. J. Heat Mass Transfer, 27(9), pp. 1641–1648) and the Bishop correlation (Bishop et al., 1964, “Forced-Convection Heat Transfer to Water at Near-Critical Temperatures and Supercritical Pressures,” Westinghouse Electric Corp, Atomic Power Division, Pittsburgh, PA.) for the post-CHF heat transfer coefficient were adjusted to better predict the experimental results. Additionally, an enhancement factor was derived to predict the increase in the heat transfer coefficient in the developing region.