| description abstract | The coupling between different components of a turbomachinery is becoming more widely studied especially by use of computational fluid dynamics. Such simulations are of particular interest especially at the interface between a combustion chamber and a turbine, for which the prediction of the migration of hotspots generated in the chamber is of paramount importance for performance and life-duration issues. Despite this need for fully integrated simulations, typical turbomachinery simulations however often only consider isolated components with either time-averaged constant value, radial profile or least frequently two-dimensional maps imposed at their inlet boundaries preventing any accurate two-way coupling. The objective of this study is to investigate available solutions to perform isolated simulations while taking into account the effect of multicomponent coupling. Investigations presented in the paper focus on the full aero-thermal combustor-turbine interaction research (FACTOR) configuration. The first step of the proposed method is to record conservative variables solved by the large-eddy simulation (LES) code at the interface plane between the chamber and the turbine of a reference simulation. Then, using the spectral proper orthogonal decomposition (SPOD) method, the recorded data is analyzed and can be partially reconstructed using different numbers of frequencies. Using the partial reconstructions, it is then possible to replicate a realistic inlet boundary condition for isolated turbine simulations with both velocity and temperature fluctuations, while reducing the storage cost compared to the initial database. The integrated simulation is then compared to the isolated simulations as well as against simulations making use of averaged quantities with or without synthetic turbulence injection at their inlet. The isolated simulations for which the inlet condition is reconstructed with a large number of frequencies show very good agreement with the fully integrated simulation compared to the typical isolated simulation using average quantities at the inlet. As expected, decreasing the number of frequencies in the reconstructed signal deteriorates the accuracy of the resulting signal compared to the full recorded database. However, isolated simulations with a low number of frequencies still perform better than standard boundary conditions, especially from an aero-thermal point of view. | |
