Effects of Process Parameters on Crack Inhibition and Mechanical Interlocking in Friction Self-Piercing Riveting of Aluminum Alloy and Magnesium Alloy

Abstract

Friction self-piercing riveting (F-SPR) process has shown advantages over fusion welding, solid state welding, and traditional mechanical joining processes in joining dissimilar materials. Because of the thermo-mechanical nature of F-SPR process, formation of the joint is determined by both riveting force and softening degree of materials to be joined. However, it is still not clear that how exactly the riveting force and generated frictional heat jointly influence mechanical interlocking formation and crack inhibition during F-SPR process. To address these issues, F-SPR process was applied to join 2.2 mm-thick aluminum alloy AA6061-T6 to 2.0 mm-thick magnesium alloy AZ31B. The correlation of riveting force, torque responses, and energy input with joint quality was investigated systematically under a wide range of process parameter combinations. It was found that a relatively greater final peak force and higher energy input were favorable to produce sound joints. Based on that, a two-stage F-SPR method was proposed to better control the energy input and riveting force for improved joint quality. The joints produced by the two-stage method exhibited significantly improved lap-shear strength, i.e., 70% higher than traditional self-piercing riveting (SPR) joints and 30% higher than previous one-stage F-SPR joints. This research provides a valuable reference for further understanding the F-SPR joint formation mechanism and conducting process optimization.