Browsing Journal of Vibration and Acoustics by Issue Date
Now showing items 1-20 of 3827
-
On the Influence of Nonlinear Inertial Forces on the Limit Cycle Oscillations of an Inextensible Plate in a Supersonic Axial Flow
(The American Society of Mechanical Engineers (ASME), 1/5/2023 1)Recent results in the literature highlight the impact of nonlinear inertial forces on the post-flutter limit cycle oscillation (LCO) characteristics of highly deflected structures in supersonic axial flow. The current ... -
Characteristics of Self-Excited Vibration of Vertical Rotating Shaft System Considering Amplitude Dependent Nonlinearity of Sliding Bearing
(The American Society of Mechanical Engineers (ASME), 11/2/2022 )Journal sliding bearings are often used to support rotating machinery to add damping and increase load capacity. These bearings have strong nonlinearities that can cause vibration problems. Various studies have been conducted ... -
Wave Transmission and Energy Dissipation at Structural and Machine Joints
(The American Society of Mechanical Engineers (ASME), 1983)The dynamics of composed structures is influenced by the transfer behavior of interfaces of bolted, riveted, and compression joints. The measured nonlinear behavior of such joints is represented ... -
Determination of AGMA Geometry Factor J for Slotted External Spur Gears
(The American Society of Mechanical Engineers (ASME), 1983)This paper presents a direct method for determining the geometry factor J for slotted external spur gears. The location of maximum stressed point on the tooth profile where the stress parabola ... -
Proceedings of Inter-Noise ’82
(The American Society of Mechanical Engineers (ASME), 1983) -
The Steady-State Response of a Cantilevered Rotor With Skew and Mass Unbalances
(The American Society of Mechanical Engineers (ASME), 1983)The steady state response of a cantilevered rotor with skew and mass unbalances is studied, with special attention to the effects due to skew. A disk misaligned with its drive shaft receives ... -
Aeroelastic Characteristics of a Cascade of Mistuned Blades in Subsonic and Supersonic Flows
(The American Society of Mechanical Engineers (ASME), 1983)An investigation of the effects of mistuning on flutter and forced response of a cascade in subsonic and supersonic flows is presented. The aerodynamic and structural coupling between the bending ... -
Structural Damping by Slip in Joints
(The American Society of Mechanical Engineers (ASME), 1983)The analysis of slip in riveted or bolted joints during harmonic excitation has been the subject of much research. However, in the case of plates the slip is induced by in-plane forces which ... -
Fundamentals of Acoustics (3rd Ed.)
(The American Society of Mechanical Engineers (ASME), 1983) -
Noise and Vibration
(The American Society of Mechanical Engineers (ASME), 1983) -
A Parametric Study of Dynamic Response of a Discrete Model of Turbomachinery Bladed Disk
(The American Society of Mechanical Engineers (ASME), 1983)A model consisting of n five-degree-of-freedom subsystems has been developed to characterize some of the mechanical response features of a bladed disk system, including four modes of each blade, ... -
Eigenanalysis of the Rigid Body Motion Effect on Elastic Systems
(The American Society of Mechanical Engineers (ASME), 1983)In this paper, the influence of rigid body motion on the behavior of a vibrating elastic system is treated by the development of a difference eigenvalue problem. The maximum possible changes ... -
Determination of Vibration Amplitudes and Stresses Using the Holography Interference Techniques and Finite Element Method
(The American Society of Mechanical Engineers (ASME), 1983)A new method which combines the holography interference technique with the finite element method for determining the distribution of vibration amplitudes and stresses of gas turbine compressor ... -
Programming Methods in Structural Dynamics
(The American Society of Mechanical Engineers (ASME), 1983) -
Natural Frequencies of Rotating Bladed Disks Using Clamped-Free Blade Modes
(The American Society of Mechanical Engineers (ASME), 1983)The problem of calculating the natural frequencies of a practical rotating bladed disk assembly is solved by use of a new dynamic substructuring method employing the free modes of the disk ... -
Prediction of Aircraft Interior Noise Using the Statistical Energy Analysis Method
(The American Society of Mechanical Engineers (ASME), 1983)An analytical model is developed to predict the transmission of noise into an airplane interior through the fuselage sidewall by the statistical energy analysis (SEA) method. The fuselage structure ... -
On a Finite Element Formulation of Dynamical Torsion of Beams Including Warping Inertia and Shear Deformation Due to Nonuniform Warping
(The American Society of Mechanical Engineers (ASME), 1983)We start from the energetical expressions of dynamical torsion of beams in terms of angular and warping displacement and velocity. We derive the stiffness and two mass matrices including both ... -
Computer Simulation of an Impulse Heat Sealing Machine
(The American Society of Mechanical Engineers (ASME), 1983)Reduced computing costs and continued development of computational methods of heat transfer make it possible to simulate complicated heat sealing processes on a computer. Such a simulation is ... -
Seismic Analysis of a Gyroscopic Mechanical System
(The American Society of Mechanical Engineers (ASME), 1983)The dynamic analysis of a gyroscopic mechanical system subjected to seismic excitation is presented. The gyroscopic system consists of a rigid rotor mounted on fluid film bearings. The seismic ... -
Dynamics of Coupled Fluid-Structure Multiplate Systems
(The American Society of Mechanical Engineers (ASME), 1983)A general formulation, for the study of free vibrations and frequency response of a multiplate system fully submerged in fluid contained in an enclosure, has been presented. Although the ...