Journal of Electrochemical Energy Conversion and Storage: Recent submissions
Now showing items 121-140 of 470
-
Exploring the Influence of Bismuth Content on the Electrochemical Performance of Aluminum Anodes in Aluminum-Air Battery
(The American Society of Mechanical Engineers (ASME), 2022)Bi is one of important alloying elements in aluminum anode of alkaline batteries. In this work, Al–Bi alloy is used as anode material. And how to optimize the addition amount of Bi in aluminum anode was studied to improve ... -
Influence of Electrode Parameters on the Performance Behavior of Lithium-Ion Battery
(The American Society of Mechanical Engineers (ASME), 2022)The importance of lithium-ion batteries in renewable energy storage applications cannot be sufficiently explained and can be used in hybrid vehicles, electronic devices, wearable electronics, and so on because of their ... -
Efficient Extraction of Mn2+ Ions From the Waste Produced in the Hummers Method for Application in Li-Ion Batteries
(The American Society of Mechanical Engineers (ASME), 2022)Graphene nanosheets are produced in mass by Hummers method, accompanied with the emission of waste acid effluent with Mn2+, which should be reasonably recycled. Herein, Mn2+ was extracted into Mn3O4 nanoparticles by oxidation ... -
Fault Detection of Single Cell Battery Inconsistency in Electric Vehicle Based on Fireworks Algorithm Optimized Deep Belief Network
(The American Society of Mechanical Engineers (ASME), 2022)Because the fault characteristics of inconsistent fault single battery are not obvious in the electric vehicle battery pack, it is difficult to identify the inconsistent fault. Therefore, this paper proposes an inconsistent ... -
Optimal Control of Active Cell Balancing for Lithium-Ion Battery Pack With Constraints on Cells’ Current and Temperature
(The American Society of Mechanical Engineers (ASME), 2022)Cell balancing control for Li-ion battery pack plays an important role in the battery management system. It contributes to maintaining the maximum usable capacity, extending the cycle life of cells, and preventing overheating ... -
On the Influence of Ball Milling Time on the Structure and Electrochemical Performance of (Sn71Co29)50C50 wt% Anodes for Li-Ion Battery Applications
(The American Society of Mechanical Engineers (ASME), 2022)Ball milled SnCoC composites are an attractive commercial anode material to conventional graphite due to their higher specific capacity and low temperature performance. The effect of ball milling time on the structure and ... -
Lithium-Ion Battery Strain Gauge Monitoring and Depth of Discharge Estimation
(The American Society of Mechanical Engineers (ASME), 2022)Lithium-ion battery diagnostics and prognostics rely on measurements of electrical impedance, capacity, and voltage to infer the internal state of the battery. Mechanical changes to the cell structure represent an additional ... -
Emulating Spatial and Temporal Outputs From Fuel Cell and Battery Models: A Comparison of Deep Learning and Gaussian Process Models
(The American Society of Mechanical Engineers (ASME), 2022)Neural network models have a long history in fuel cell and battery modeling. With the recent advent of deep learning, there is potential for further improvements in these models. Conversely, deep learning is primarily ... -
Improving the Electrochemical Performance of Lithium-Rich Cathode Materials by Vanadium and Titanium Co-Doping Using Solution Combustion Synthesis
(The American Society of Mechanical Engineers (ASME), 2022)A lithium-rich layered oxide cathode material (Li1.2[Mn0.54Ni0.13Co0.13]O2) was synthesized using solution combustion synthesis, and the electrochemical effects of co-doping with vanadium and titanium were studied. Materials ... -
Improved Interfacial Property of Na3V2(PO4)3@C Cathode: Application of NaODFB-Based Ether Electrolyte in Sodium-Ion Batteries
(The American Society of Mechanical Engineers (ASME), 2022)Sodium-ion batteries are considered as one of the most promising energy storage technologies that may replace lithium-ion batteries in the future. NaODFB, a new chelated sodium salt with the specific structural, has not ... -
Porous Carbon With Facial Tuning of the Heteroatom N by Polyvinylidene Chloride Dehalogenation Toward Enhanced Supercapacitor Performance
(The American Society of Mechanical Engineers (ASME), 2022)Porous carbon with a high surface area has attracted wide attention in energy storage systems due to its fast charge−discharge rate and exceptional rate capability. However, it is still a challenge to design electrochemical ... -
Experimental Investigation on the Concentration Polarization and Power Output of a Reverse Electrodialysis Stack With Permselective Spacers for Different Factors
(The American Society of Mechanical Engineers (ASME), 2022)The use of permselective spacers in reverse electrodialysis (RED) stack introduces a more severe concentration polarization phenomenon at membrane–solution interfaces in spite of effectively suppressing the spacer shadow ... -
Effect of Annealing on the Defects and Morphology of Cu9S5: Implication for Advanced Electrode for Asymmetric Supercapacitors
(The American Society of Mechanical Engineers (ASME), 2022)Introduction of defects and engineering of structure play significant roles in improvement on electrochemical performances of copper sulfide (Cu9S5) as a supercapacitors (SCs) electrode. Herein, a hierarchical rose-shaped ... -
Combined Effects of Citric Acid and Ascorbic Acid Used As Low-Temperature Surface Modifiers to Enhance the Cyclability of Si Anode in an Li-Ion Battery
(The American Society of Mechanical Engineers (ASME), 2022)We successfully achieved surface modification of Si at a low temperature (150 °C) by using citric acid and ascorbic acid as surface modifiers and enhanced the electrochemical performance of a Si-based anode. A simple ... -
X-Ray Induced Chemical Reaction Revealed by In Situ X-Ray Diffraction and Scanning X-Ray Microscopy in 15 nm Resolution
(The American Society of Mechanical Engineers (ASME), 2022)The detection sensitivity of synchrotron-based X-ray techniques has been largely improved due to the ever-increasing source brightness, which has significantly advanced ex situ and in situ research for energy materials ... -
Three-Dimensional Modeling of Electrochemical Behavior in SiO/Graphite Composite Anode for High Energy Density Lithium-Ion Battery
(The American Society of Mechanical Engineers (ASME), 2022)SiO/Graphite (Gr) composite has been regarded as one of the most promising anode materials for the next generation of high-energy-density lithium-ion batteries (LIBs). The heterogeneous composition of such an anode system ... -
Crystallographic Design of Intercalation Materials
(The American Society of Mechanical Engineers (ASME), 2022)Intercalation materials are promising candidates for reversible energy storage and are, for example, used as lithium-battery electrodes, hydrogen-storage compounds, and electrochromic materials. An important issue preventing ... -
Emerging Investigators in Electrochemical Energy Conversion and Storage 2022
(The American Society of Mechanical Engineers (ASME), 2022)This special issue features the 2022 Emerging Investigators in Electrochemical Energy Conversion and Storage. Eleven emerging investigators were invited to this special issue to showcase up-and-coming scientists and engineers ... -
Mechanical Properties of Prismatic Li-Ion Batteries—Electrodes, Cells, and Stacks
(The American Society of Mechanical Engineers (ASME), 2022)Mechanical abusive loadings, as an inevitable consequence of road accidents, can damage the embedded energy storage system in an electric vehicle and deform its constitutive parts, e.g., the lithium-ion batteries. Therefore, ... -
Computational Elucidation of Mechanical Degradation in NMC Cathodes: Impact on Cell Performance
(The American Society of Mechanical Engineers (ASME), 2022)Next-generation lithium ion batteries are expected to demonstrate superior energy and power density with longer cycle life for successful electrification of the automobile, aviation, and marine industries. Adoption of ...