| contributor author | D. S. Ermer | |
| contributor author | B. V. Shah | |
| date accessioned | 2017-05-09T01:37:05Z | |
| date available | 2017-05-09T01:37:05Z | |
| date copyright | February, 1973 | |
| date issued | 1973 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27583#312_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/164146 | |
| description abstract | An analytical method for sensitivity studies in the determination of the optimum machining conditions for the single point turning process was previously presented by Ermer and Faria [4]. In the present paper, an analytical method for sensitivity studies in the determination of the optimum machining conditions for milling, drilling, reaming and tapping is presented, assuming that the optimizing criterion is minimum cost or maximum production rate. A nomogram is given which provides a simple and efficient way to carry out quantitative sensitivity analyses. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Analytical Sensitivity Studies of the Optimum Machining Conditions for Milling, Drilling, Reaming, and Tapping | |
| type | Journal Paper | |
| journal volume | 95 | |
| journal issue | 1 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.3438128 | |
| journal fristpage | 312 | |
| journal lastpage | 316 | |
| identifier eissn | 1528-8935 | |
| keywords | Machining | |
| keywords | Drilling | |
| keywords | Milling AND Sensitivity analysis | |
| tree | Journal of Manufacturing Science and Engineering:;1973:;volume( 095 ):;issue: 001 | |
| contenttype | Fulltext | |