Fracture of Flat and Curved Aluminum Sheets With Stiffeners Parallel to the CrackSource: Journal of Fluids Engineering:;1961:;volume( 083 ):;issue: 001::page 32Author:J. Frisch
DOI: 10.1115/1.3658887Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The mode of crack propagation and failure in relatively large 2024-T3 aluminum sheets reinforced with stiffeners parallel to the crack direction has been investigated. Curved specimens with a 69-in. radius of curvature as well as flat panels were subjected to uniaxial tension perpendicular to a simulated crack to study the effects of curvature, crack location, and stiffener spacing. Increase in strength due to stiffening particularly in the curved panels was observed although these specimens exhibited considerable lower crack strength than flat ones. For the specimens tested, crack location as well as variations of stiffener spacing from 3 to 12 in. had no appreciable effect on either critical crack length or failure stress.
keyword(s): Aluminum , Fracture (Process) , Fracture (Materials) , Failure , Tension , Crack propagation AND Stress ,
|
Collections
Show full item record
| contributor author | J. Frisch | |
| date accessioned | 2017-05-09T01:36:51Z | |
| date available | 2017-05-09T01:36:51Z | |
| date copyright | March, 1961 | |
| date issued | 1961 | |
| identifier issn | 0098-2202 | |
| identifier other | JFEGA4-27228#32_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/164029 | |
| description abstract | The mode of crack propagation and failure in relatively large 2024-T3 aluminum sheets reinforced with stiffeners parallel to the crack direction has been investigated. Curved specimens with a 69-in. radius of curvature as well as flat panels were subjected to uniaxial tension perpendicular to a simulated crack to study the effects of curvature, crack location, and stiffener spacing. Increase in strength due to stiffening particularly in the curved panels was observed although these specimens exhibited considerable lower crack strength than flat ones. For the specimens tested, crack location as well as variations of stiffener spacing from 3 to 12 in. had no appreciable effect on either critical crack length or failure stress. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Fracture of Flat and Curved Aluminum Sheets With Stiffeners Parallel to the Crack | |
| type | Journal Paper | |
| journal volume | 83 | |
| journal issue | 1 | |
| journal title | Journal of Fluids Engineering | |
| identifier doi | 10.1115/1.3658887 | |
| journal fristpage | 32 | |
| journal lastpage | 38 | |
| identifier eissn | 1528-901X | |
| keywords | Aluminum | |
| keywords | Fracture (Process) | |
| keywords | Fracture (Materials) | |
| keywords | Failure | |
| keywords | Tension | |
| keywords | Crack propagation AND Stress | |
| tree | Journal of Fluids Engineering:;1961:;volume( 083 ):;issue: 001 | |
| contenttype | Fulltext |