Show simple item record

contributor authorAhrens, Denise
contributor authorKolb, Michael
contributor authorHirsch, Christoph
contributor authorSattelmayer, Thomas
date accessioned2017-05-09T01:28:39Z
date available2017-05-09T01:28:39Z
date issued2016
identifier issn1528-8919
identifier othergtp_138_08_081506.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/161139
description abstractAxial staging in premixed gas turbine combustors is a promising option for the increase in firing temperature without NOx penalty and for the improvement of turndown ratio, which is limited by the onset of COemissions. The configuration of greatest interest is the combination of state of the art premixed combustion in the primary stage with secondary injectors near the turbine inlet, which feed additional jets of premixed combustible mixture into the hot cross flow. Regarding NOx, this configuration is particularly beneficial (1) if the overall mixing quality in the first stage is limited, (2) if the difference between primary zone flame temperature and turbine inlet temperature due to air addition along the combustor is large, and (3) if a high degree of mixing in the second stage is achieved. The potential of this promising combustion concept was investigated in a large scale atmospheric test rig. For the study presented below, scaling of the second stage according to Karlovitz number similarity was chosen. This leads to smaller jet diameters and higher injection velocities compared to scaling based on Damkأ¶hler number applied in an earlier study. The impact of the higher velocities at the injector outlet on the flow field, on the liftoff height of the flame and on NOx formation is analyzed. A chemical network model is presented, which illustrates the effects of preflame and postflame mixing on NOx formation under atmospheric and high pressure conditions. In addition, this model is used to study the interactions of chemistry with mixing between the reacting jet and cross flow. On the basis of atmospheric testing and reactor modeling, predictions for engine pressure are made assuming similar liftoff as well as pre and postflame mixing. These results are further analyzed regarding the NOx reduction potential at different equivalence ratios and residence times. Finally, it is discussed under which conditions the investigated configuration can be beneficially applied to reduce NOxemissions of real engines.
publisherThe American Society of Mechanical Engineers (ASME)
titleInfluence of Preflame and Postflame Mixing on NOx Formation in a Reacting Premixed Jet in Hot Cross Flow
typeJournal Paper
journal volume138
journal issue8
journal titleJournal of Engineering for Gas Turbines and Power
identifier doi10.1115/1.4032420
journal fristpage81506
journal lastpage81506
identifier eissn0742-4795
treeJournal of Engineering for Gas Turbines and Power:;2016:;volume( 138 ):;issue: 008
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record