YaBeSH Engineering and Technology Library

    • Journals
    • PaperQuest
    • YSE Standards
    • YaBeSH
    • Login
    View Item 
    •   YE&T Library
    • ASME
    • Journal of Energy Resources Technology
    • View Item
    •   YE&T Library
    • ASME
    • Journal of Energy Resources Technology
    • View Item
    • All Fields
    • Source Title
    • Year
    • Publisher
    • Title
    • Subject
    • Author
    • DOI
    • ISBN
    Advanced Search
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Archive

    Diesel Like Efficiency Using Compressed Natural Gas/Diesel Dual Fuel Combustion

    Source: Journal of Energy Resources Technology:;2016:;volume( 138 ):;issue: 005::page 52201
    Author:
    Nithyanandan, Karthik
    ,
    Zhang, Jiaxiang
    ,
    Li, Yuqiang
    ,
    Meng, Xiangyu
    ,
    Donahue, Robert
    ,
    Lee, Chia
    ,
    Dou, Huili
    DOI: 10.1115/1.4032621
    Publisher: The American Society of Mechanical Engineers (ASME)
    Abstract: The use of natural gas in compression ignition (CI) engines as a supplement to diesel under dualfuel combustion mode is a promising technique to increase efficiency and reduce emissions. In this study, the effect of dualfuel operating mode on combustion characteristics, engine performance and pollutant emissions of a diesel engine using natural gas as primary fuel and neat diesel as pilot fuel, has been examined. Natural gas (99% methane) was port injected into an AVL 5402 single cylinder diesel research engine under various engine operating conditions and up to 90% substitution was achieved. In addition, neat diesel was also tested as a baseline for comparison. The experiments were conducted at three different speeds—1200, 1500, and 2000 rpm, and at different dieselequivalent loads (injection quantity)—15, 20 (7 bar IMEP), and 25 mg/cycle. Both performance and emissions data are presented and discussed. The performance was evaluated through measurements of incylinder pressure, power output and various exhaust emissions including unburned hydrocarbons (UHCs), carbon monoxide (CO), nitrogen oxides (NOx), and soot. The goal of these experiments was to maximize the efficiency. This was done as follows—the compressed natural gas (CNG) substitution rate (based on energy) was increased from 30% to 90% at fixed engine conditions, to identify the optimum CNG substitution rate. Then using that rate, a main injection timing sweep was performed. Under these optimized conditions, combustion behavior was also compared between single, double, and triple injections. Finally, a load and speed sweep at the optimum CNG rate and timings were performed. It was found that a 70% CNG substitution provided the highest indicated thermal efficiency (ITE). It appears that dualfuel combustion has a maximum brake torque (MBT) diesel injection timing for different conditions which provides the highest torque. Based on multiple diesel injection tests, it was found that the conditions that favor pure diesel combustion, also favor dualfuel combustion because better diesel combustion provides better ignition and combustion for the CNGair mixture. For 70% CNG dualfuel combustion, multiple diesel injections showed an increase in the efficiency. Based on the experiments conducted, dieselCNG dualfuel combustion is able to achieve similar efficiency and reduced emissions relative to pure diesel combustion. As such, CNG can be effectively used to substitute for diesel fuel in CI engines.
    • Download: (2.621Mb)
    • Show Full MetaData Hide Full MetaData
    • Get RIS
    • Item Order
    • Go To Publisher
    • Price: 5000 Rial
    • Statistics

      Diesel Like Efficiency Using Compressed Natural Gas/Diesel Dual Fuel Combustion

    URI
    http://yetl.yabesh.ir/yetl1/handle/yetl/160902
    Collections
    • Journal of Energy Resources Technology

    Show full item record

    contributor authorNithyanandan, Karthik
    contributor authorZhang, Jiaxiang
    contributor authorLi, Yuqiang
    contributor authorMeng, Xiangyu
    contributor authorDonahue, Robert
    contributor authorLee, Chia
    contributor authorDou, Huili
    date accessioned2017-05-09T01:27:47Z
    date available2017-05-09T01:27:47Z
    date issued2016
    identifier issn0195-0738
    identifier otherjert_138_05_052201.pdf
    identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/160902
    description abstractThe use of natural gas in compression ignition (CI) engines as a supplement to diesel under dualfuel combustion mode is a promising technique to increase efficiency and reduce emissions. In this study, the effect of dualfuel operating mode on combustion characteristics, engine performance and pollutant emissions of a diesel engine using natural gas as primary fuel and neat diesel as pilot fuel, has been examined. Natural gas (99% methane) was port injected into an AVL 5402 single cylinder diesel research engine under various engine operating conditions and up to 90% substitution was achieved. In addition, neat diesel was also tested as a baseline for comparison. The experiments were conducted at three different speeds—1200, 1500, and 2000 rpm, and at different dieselequivalent loads (injection quantity)—15, 20 (7 bar IMEP), and 25 mg/cycle. Both performance and emissions data are presented and discussed. The performance was evaluated through measurements of incylinder pressure, power output and various exhaust emissions including unburned hydrocarbons (UHCs), carbon monoxide (CO), nitrogen oxides (NOx), and soot. The goal of these experiments was to maximize the efficiency. This was done as follows—the compressed natural gas (CNG) substitution rate (based on energy) was increased from 30% to 90% at fixed engine conditions, to identify the optimum CNG substitution rate. Then using that rate, a main injection timing sweep was performed. Under these optimized conditions, combustion behavior was also compared between single, double, and triple injections. Finally, a load and speed sweep at the optimum CNG rate and timings were performed. It was found that a 70% CNG substitution provided the highest indicated thermal efficiency (ITE). It appears that dualfuel combustion has a maximum brake torque (MBT) diesel injection timing for different conditions which provides the highest torque. Based on multiple diesel injection tests, it was found that the conditions that favor pure diesel combustion, also favor dualfuel combustion because better diesel combustion provides better ignition and combustion for the CNGair mixture. For 70% CNG dualfuel combustion, multiple diesel injections showed an increase in the efficiency. Based on the experiments conducted, dieselCNG dualfuel combustion is able to achieve similar efficiency and reduced emissions relative to pure diesel combustion. As such, CNG can be effectively used to substitute for diesel fuel in CI engines.
    publisherThe American Society of Mechanical Engineers (ASME)
    titleDiesel Like Efficiency Using Compressed Natural Gas/Diesel Dual Fuel Combustion
    typeJournal Paper
    journal volume138
    journal issue5
    journal titleJournal of Energy Resources Technology
    identifier doi10.1115/1.4032621
    journal fristpage52201
    journal lastpage52201
    identifier eissn1528-8994
    treeJournal of Energy Resources Technology:;2016:;volume( 138 ):;issue: 005
    contenttypeFulltext
    DSpace software copyright © 2002-2015  DuraSpace
    نرم افزار کتابخانه دیجیتال "دی اسپیس" فارسی شده توسط یابش برای کتابخانه های ایرانی | تماس با یابش
    yabeshDSpacePersian
     
    DSpace software copyright © 2002-2015  DuraSpace
    نرم افزار کتابخانه دیجیتال "دی اسپیس" فارسی شده توسط یابش برای کتابخانه های ایرانی | تماس با یابش
    yabeshDSpacePersian