Impingement Heat Transfer From Jet Arrays on Turbulated Target Walls at Large Reynolds Numbers

Abstract

Experiments to investigate heat transfer and pressure loss from jet array impingement are performed on the target wall at high Reynolds numbers. Reynolds numbers up to 450,000 are tested. The presence of a turbulated target wall and its effect on heat transfer enhancement against a smooth surface is investigated. Two different jet plate configurations are used with closely spaced holes and with angled as well as normal impingement holes. The test section crosssection is designed to expand along the streamwise direction maintaining the jet plate to target wall distance in order to reduce crossflow effects. The jet plate holes are chamfered or filleted to minimize pressure loss through the jet plate. Heat transfer and pressure loss measurements are performed on a smooth target wall as well as turbulated target walls. Three turbulators configurations are used with streamwise riblets, short pins, and spherical dimples. A steadystate heat transfer measurement method is used to obtain the heat transfer coefficients while pressure taps located in the plenum and at several streamwise locations are used to record the pressure losses across the jet plate. Experiments are performed for a range of Reynolds numbers from 50,000 to 450,000 based on average jet hole diameters to cover the incompressible as well as compressible flow regimes. A target wall with short pins provides the best heat transfer with the dimpled target wall giving the lowest heat transfer among the three turbulators geometries studied. Addition of turbulators though does not significantly increase the pressure losses in the test section over the smooth target wall.