Development and Validation of Endovascular Chemotherapy Filter Device for Removing High Dose Doxorubicin: Preclinical StudySource: Journal of Medical Devices:;2014:;volume( 008 ):;issue: 004::page 41008Author:Patel, Anand S.
,
Saeed, Maythem
,
Yee, Erin J.
,
Yang, Jeffrey
,
Lam, Gregory J.
,
Losey, Aaron D.
,
Lillaney, Prasheel V.
,
Thorne, Bradford
,
Chin, Albert K.
,
Malik, Sheena
,
Wilson, Mark W.
,
Chen, Xi C.
,
Balsara, Nitash P.
,
Hetts, Steven W.
DOI: 10.1115/1.4027444Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: To develop a novel endovascular chemotherapy filter (CF) able to remove excess drug from the blood during intraarterial chemotherapy delivery (IAC), thus preventing systemic toxicities and thereby enabling higher dose IAC. A flow circuit containing 2.5 mL of ionexchange resin was constructed. Phosphatebuffered saline (PBS) containing 50 mg doxorubicin (Dox) was placed in the flow model with the hypothesis that doxorubicin would bind rapidly to resin. To simulate IAC, 50 mg of doxorubicin was infused over 10 min into the flow model containing resin. Similar testing was repeated with porcine serum. Doxorubicin concentrations were measured over 60 min and compared to controls (without resin). Singlepass experiments were also performed. Based on these experiments, an 18F CF was constructed with resin in its tip. In a pilot porcine study, the device was deployed under fluoroscopy. A control hepatic doxorubicin IAC model (no CF placed) was developed in another animal. A second CF device was created with a resin membrane and tested in the infrarenal inferior vena cava (IVC) of a swine. In the PBS model, resin bound 76% of doxorubicin in 10 min, and 92% in 30 min (P < 0.001). During IAC simulation, 64% of doxorubicin bound in 10 min and 96% in 60 min (P < 0.001). On average, 51% of doxorubicin concentration was reduced during each pass in single pass studies. In porcine serum, 52% of doxorubicin bound in 10 min, and 80% in 30 min (P < 0.05). CF device placement and administration of IAC were successful in three animals. No clot was present on the resin within the CF following the in vivo study. The infrarenal IVC swine study demonstrated promising results with up to 85% reduction in peak concentration by the CF device. An endovascular CF device was developed and shown feasible in vitro. An in vivo model was established with promising results supporting highcapacity rapid doxorubicin filtration from the blood that can be further evaluated in future studies.
|
Collections
Show full item record
| contributor author | Patel, Anand S. | |
| contributor author | Saeed, Maythem | |
| contributor author | Yee, Erin J. | |
| contributor author | Yang, Jeffrey | |
| contributor author | Lam, Gregory J. | |
| contributor author | Losey, Aaron D. | |
| contributor author | Lillaney, Prasheel V. | |
| contributor author | Thorne, Bradford | |
| contributor author | Chin, Albert K. | |
| contributor author | Malik, Sheena | |
| contributor author | Wilson, Mark W. | |
| contributor author | Chen, Xi C. | |
| contributor author | Balsara, Nitash P. | |
| contributor author | Hetts, Steven W. | |
| date accessioned | 2017-05-09T01:11:22Z | |
| date available | 2017-05-09T01:11:22Z | |
| date issued | 2014 | |
| identifier issn | 1932-6181 | |
| identifier other | med_008_04_041008.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/155964 | |
| description abstract | To develop a novel endovascular chemotherapy filter (CF) able to remove excess drug from the blood during intraarterial chemotherapy delivery (IAC), thus preventing systemic toxicities and thereby enabling higher dose IAC. A flow circuit containing 2.5 mL of ionexchange resin was constructed. Phosphatebuffered saline (PBS) containing 50 mg doxorubicin (Dox) was placed in the flow model with the hypothesis that doxorubicin would bind rapidly to resin. To simulate IAC, 50 mg of doxorubicin was infused over 10 min into the flow model containing resin. Similar testing was repeated with porcine serum. Doxorubicin concentrations were measured over 60 min and compared to controls (without resin). Singlepass experiments were also performed. Based on these experiments, an 18F CF was constructed with resin in its tip. In a pilot porcine study, the device was deployed under fluoroscopy. A control hepatic doxorubicin IAC model (no CF placed) was developed in another animal. A second CF device was created with a resin membrane and tested in the infrarenal inferior vena cava (IVC) of a swine. In the PBS model, resin bound 76% of doxorubicin in 10 min, and 92% in 30 min (P < 0.001). During IAC simulation, 64% of doxorubicin bound in 10 min and 96% in 60 min (P < 0.001). On average, 51% of doxorubicin concentration was reduced during each pass in single pass studies. In porcine serum, 52% of doxorubicin bound in 10 min, and 80% in 30 min (P < 0.05). CF device placement and administration of IAC were successful in three animals. No clot was present on the resin within the CF following the in vivo study. The infrarenal IVC swine study demonstrated promising results with up to 85% reduction in peak concentration by the CF device. An endovascular CF device was developed and shown feasible in vitro. An in vivo model was established with promising results supporting highcapacity rapid doxorubicin filtration from the blood that can be further evaluated in future studies. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Development and Validation of Endovascular Chemotherapy Filter Device for Removing High Dose Doxorubicin: Preclinical Study | |
| type | Journal Paper | |
| journal volume | 8 | |
| journal issue | 4 | |
| journal title | Journal of Medical Devices | |
| identifier doi | 10.1115/1.4027444 | |
| journal fristpage | 41008 | |
| journal lastpage | 41008 | |
| identifier eissn | 1932-619X | |
| tree | Journal of Medical Devices:;2014:;volume( 008 ):;issue: 004 | |
| contenttype | Fulltext |