Show simple item record

contributor authorDwivedi, U.
contributor authorCarpenter, C. D.
contributor authorGuerry, E. S.
contributor authorPolk, A. C.
contributor authorKrishnan, S. R.
contributor authorSrinivasan, K. K.
date accessioned2017-05-09T01:07:57Z
date available2017-05-09T01:07:57Z
date issued2014
identifier issn1528-8919
identifier othergtp_136_10_101504.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/154808
description abstractDieselignited gasoline dual fuel combustion experiments were performed in a singlecylinder research engine (SCRE), outfitted with a commonrail diesel injection system and a standalone engine controller. Gasoline was injected in the intake port using a portfuel injector. The engine was operated at a constant speed of 1500 rev/min, a constant load of 5.2 bar indicated mean effective pressure (IMEP), and a constant gasoline energy substitution of 80%. Parameters such as diesel injection timing (SOI), diesel injection pressure, and boost pressure were varied to quantify their impact on engine performance and engineout indicated specific nitrogen oxide emissions (ISNOx), indicated specific hydrocarbon emissions (ISHC), indicated specific carbon monoxide emissions (ISCO), and smoke emissions. Advancing SOI from 30 degrees before top dead center (DBTDC) to 60 DBTDC reduced ISNOx from 14 g/kW h to less than 0.1 g/kW h; further advancement of SOI did not yield significant ISNOx reduction. A fundamental change was observed from heterogeneous combustion at 30 DBTDC to “premixed enoughâ€‌ combustion at 50–80 DBTDC and finally to wellmixed dieselassisted gasoline homogeneous charge compression ignition (HCCI)like combustion at 170 DBTDC. Smoke emissions were less than 0.1 filter smoke number (FSN) at all SOIs, while ISHC and ISCO were in the range of 8–20 g/kW h, with the earliest SOIs yielding very high values. Indicated fuel conversion efficiencies were ∼ 40–42.5%. An injection pressure sweep from 200 to 1300 bar at 50 DBTDC SOI and 1.5 bar intake boost showed that very low injection pressures lead to more heterogeneous combustion and higher ISNOx and ISCO emissions, while smoke and ISHC emissions remained unaffected. A boost pressure sweep from 1.1 to 1.8 bar at 50 DBTDC SOI and 500 bar rail pressure showed very rapid combustion for the lowest boost conditions, leading to high pressure rise rates, higher ISNOx emissions, and lower ISCO emissions, while smoke and ISHC emissions remained unaffected by boost pressure variations.
publisherThe American Society of Mechanical Engineers (ASME)
titlePerformance and Emissions Characteristics of Diesel Ignited Gasoline Dual Fuel Combustion in a Single Cylinder Research Engine
typeJournal Paper
journal volume136
journal issue10
journal titleJournal of Engineering for Gas Turbines and Power
identifier doi10.1115/1.4027273
journal fristpage101504
journal lastpage101504
identifier eissn0742-4795
treeJournal of Engineering for Gas Turbines and Power:;2014:;volume( 136 ):;issue: 010
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record