Effect of Injection Timing on PPCI and MPCI Mode Fueled With Straight Run Naphtha

Abstract

Partially premixed compression ignition (PPCI) and multiple premixed compression ignition (MPCI) mode of straightrun naphtha have been investigated under different injection strategies. The MPCI mode is realized by the multiple premixed combustion processes in a sequence of “spraycombustionspraycombustionâ€‌ around the compression top dead center. The spray and combustion events are preferred to be completely separated, without any overlap in the temporal sequence in order to ensure the multiplestage premixed compression ignition. The PPCI mode is well known as the “sprayspraycombustionâ€‌ sequence, with the start of combustion separated from the end of injection. Straightrun naphtha with a research octane number (RON) of 58.8 is tested in a single cylinder compression ignition engine whose compression ratio is 16.7 and displacement is 0.5 l. Double and triple injection strategies are investigated as the last injection timing sweeping at 1.0 MPa IMEP and 1800 rpm conditions. The MPCI mode is achieved using the double injection strategy, but its soot emission is higher than the PPCI mode under triple injection strategy. This is mainly because of the lower RON of the straightrun naphtha and the ignition delay is too short to form an ideally premixed combustion process after the second injection of straightrun naphtha. Diesel fuel is also tested under the same operating conditions, except for employing a single injection strategy. The naphtha PPCI and MPCI mode both have lower fuel consumption and soot emission than diesel fuel single injection mode, but the THC emissions are both higher than that of diesel fuel.