| description abstract | Gas turbine (GT) engines employed in natural gas compressor stations operate in different modes depending on the power, turbine inlet temperature, and shaft speeds. These modes apply different sequencing of bleed valve opening on the air compressor side of the engine. Improper selection of the GT and the driven centrifugal gas compressor operating conditions can lead to larger bleed losses due to wider bleed valve openings. The bleed loss inevitably manifests itself in the form of higher overall heat rate of the GT and greater engine emission. It is, therefore, imperative to determine and understand the engine and process conditions that drive the GT to operate in these different modes. The ultimate objective is to operate the engine away from the inefficient modes by adjusting the driven gas compressor parameters as well as the overall station operating conditions (i.e., load sharing, control set points, etc.). This paper describes a methodology to couple the operating conditions of the gas compressor to the modes of GT bleed valve opening (and the subsequent air bleed rates) leading to identification of the operating parameters for optimal performance (i.e., best overall efficiency and minimum CO2e emission). A predictive tool is developed to quantify the overall efficiency loss as a result of the different bleed opening modes and map out the condition on the gas compressor characteristics. One year's worth of operating data taken from two different compressor stations on TransCanada Pipelines' Alberta system were used to demonstrate the methodology. The first station employs a GELM1600 gas turbine driving a Cooper RollsRFBB30 centrifugal compressor. The second station employs a GELM2500+ gas turbine driving NP PCL800/N compressor. The analysis conclusively indicates that there are operating regions on the gas compressor maps where losses due to bleed valves are reduced and, hence, CO2 emissions are lowered, which presents an opportunity for operation optimization. | |
