Optimization of Pipe Repair Sleeve DesignSource: Journal of Pressure Vessel Technology:;2012:;volume( 134 ):;issue: 005::page 51702Author:A. F. M. Arif
,
Nadhir I. Al-Nasri
,
Hussain M. Al-Muslim
,
Yaqoub N. Al-Nassar
,
Hussain Al-Qahtani
,
Shafique M. A. Khan
,
Muhammad Anis
,
A. M. Eleiche
,
Muhammad Inam
DOI: 10.1115/1.4006126Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: For the repair of pipeline defects, repair sleeves are the most widely used method in petrochemical industry. The objective of this work was to optimize the thickness of nonpressure containing repair sleeve, by refining the existing design practice. Laboratory studies involving instrumentation of small-scaled repair sleeve system coupled with finite element analysis were carried out to refine the design procedure and optimize the thickness of the sleeve. Using a unified approach for finite element modeling, including failure pressure estimation and simulation of sleeve installation pressure, 24 cases ranging from 6 to 60 in. nominal diameter were investigated. In this paper, the details of the optimization approach used in this investigation are presented.
keyword(s): Pressure , Maintenance , Optimization , Pipes , Failure , Design , Finite element analysis AND Thickness ,
|
Collections
Show full item record
| contributor author | A. F. M. Arif | |
| contributor author | Nadhir I. Al-Nasri | |
| contributor author | Hussain M. Al-Muslim | |
| contributor author | Yaqoub N. Al-Nassar | |
| contributor author | Hussain Al-Qahtani | |
| contributor author | Shafique M. A. Khan | |
| contributor author | Muhammad Anis | |
| contributor author | A. M. Eleiche | |
| contributor author | Muhammad Inam | |
| date accessioned | 2017-05-09T00:53:57Z | |
| date available | 2017-05-09T00:53:57Z | |
| date copyright | October, 2012 | |
| date issued | 2012 | |
| identifier issn | 0094-9930 | |
| identifier other | JPVTAS-926074#051702_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/150077 | |
| description abstract | For the repair of pipeline defects, repair sleeves are the most widely used method in petrochemical industry. The objective of this work was to optimize the thickness of nonpressure containing repair sleeve, by refining the existing design practice. Laboratory studies involving instrumentation of small-scaled repair sleeve system coupled with finite element analysis were carried out to refine the design procedure and optimize the thickness of the sleeve. Using a unified approach for finite element modeling, including failure pressure estimation and simulation of sleeve installation pressure, 24 cases ranging from 6 to 60 in. nominal diameter were investigated. In this paper, the details of the optimization approach used in this investigation are presented. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Optimization of Pipe Repair Sleeve Design | |
| type | Journal Paper | |
| journal volume | 134 | |
| journal issue | 5 | |
| journal title | Journal of Pressure Vessel Technology | |
| identifier doi | 10.1115/1.4006126 | |
| journal fristpage | 51702 | |
| identifier eissn | 1528-8978 | |
| keywords | Pressure | |
| keywords | Maintenance | |
| keywords | Optimization | |
| keywords | Pipes | |
| keywords | Failure | |
| keywords | Design | |
| keywords | Finite element analysis AND Thickness | |
| tree | Journal of Pressure Vessel Technology:;2012:;volume( 134 ):;issue: 005 | |
| contenttype | Fulltext |