Show simple item record

contributor authorJoseph C. Mollendorf
contributor authorDavid R. Pendergast
date accessioned2017-05-09T00:40:58Z
date available2017-05-09T00:40:58Z
date copyrightMarch, 2010
date issued2010
identifier issn1948-5085
identifier otherJTSEBV-28813#011003_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/144849
description abstractUnderwater workers, sport and military divers, are exposed to thermal stress since most of the waters of the world are below or above what is thermally neutral. Although divers wear insulation suits for passive thermal protection they are inadequate. Active heating is currently accomplished by resistive heating and open-flow tubes delivering hot water; however, these methods are problematic. The challenge of this project was to design, build and test an active diver thermal protection system (DTPS) to be used with wet suit insulation that is effective, user-friendly, reliable, and that could be used by a free-swimming diver. The DTPS has a minimum number of moving parts, is low maintenance, has no unsafe or toxic working fluid and uses no consumables except a safe, high density, modular electrical power source. A portable and swimmable, self-contained, electrically powered unit (DTPS) has been designed, built, and tested that produces and circulates thermally conditioned water in a closed-loop through a zoned tube suit worn by a diver under a wetsuit to maintain skin and body core temperatures within prescribed safe limits. The system has been validated by using physiological data taken on human subjects over a wide range of ambient water temperatures. Corresponding enthalpy and electrical power measurements were used as the basis of a thermodynamic analysis. The DTPS maintained skin and body core temperatures within safe and functional ranges by providing up to about 200 W of heating in cold water and up to about 330 W of cooling in hot water. The corresponding electrical power consumption was up to about 300 W in cold water and up to about 1500 W in hot water. The results of a complete audit of the power use and heat transfer are presented along with the efficiency of the thermoelectric heating/cooling modules and the duty cycle of the system for a range of water immersion temperatures from 10°C to 39°C. The DTPS proved to be an effective and reliable apparatus for diver thermal protection in water temperatures from 10°C to 39°C, which covers most of the range of the earth’s waters. The data presented here can be used to modify the design of the DTPS to meet specific needs of the diving community.
publisherThe American Society of Mechanical Engineers (ASME)
titleThermal Protection System for Underwater Use in Cold and Hot Water
typeJournal Paper
journal volume2
journal issue1
journal titleJournal of Thermal Science and Engineering Applications
identifier doi10.1115/1.4001986
journal fristpage11003
identifier eissn1948-5093
keywordsHeat
keywordsTemperature
keywordsHot water
keywordsWater
keywordsHeating
keywordsCooling
keywordsInsulation
keywordsSkin AND Flow (Dynamics)
treeJournal of Thermal Science and Engineering Applications:;2010:;volume( 002 ):;issue: 001
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record